EP3 HOW TO FLUSH OUT BOARD ENGINES WITH RYDLYME AND SAVE YOUR ENGINE FROM OVER HEATING, DONT MISS!

Рет қаралды 6,070

STEVE PERDUE'S "HOW TO" FISH, HUNT, AND MORE!

Жыл бұрын

EPISODE 3 HOW TO FLUSH OUT BOARD ENGINES WITH RYDLYME
I have 3 episodes of how to clean and build and then flush your motors with confidence that no one can argue! STOP OVER HEATING PROBLEMS FOR GOOD!
Episode 1 is RYDLYME VS SALT AWAY to verify which product I will use.
EPISODE 2 is how to build a flush system for under $200 bucks!
EPISODE 3 is how to flush with Rydlyme and use the PH tool to control its cleaning effectiveness and be sure that even a 20 year old motor is clean all the way through!
So in this episode I will show you how to flush the system and how to test if it's really cleaned your motor by simply measuring the PH level of the cleaner while its flushing!
To many people are telling you how to do this and not really getting down to the most important parts of your engines. deep inside the water jacket of your blocks and water ports.
If you watch episode 1 Rydlyme VS Salt-Away you will see why! salt a Way just does not do the trick in the amount of time people are doing it.
Why, because Salt Away does not eat up the scaling and other build up, or at least not fast enough!
If you have a used motor and didn't buy it brand new this 24hr flush is a
must!
Not only can we measure if the fluid is still cleaning but we can be confident of a good running lasting motor!
In this episode we show you the parts needed to build a flush system at home and be confident your equipment is truly clean!
No more worries,
Watch the next episode how to flush with RYDLYME and see how to measure its effective ness, it will actually tell you if there is any build up in your motors!
YOU CAN NOT BE MORE CONFIDENT THAN THAT!
Get Probing Brief by Paul Mottram and over 1M + mainstream tracks here go.lickd.co/Music License ID: PAkDME76gDB
Get Eleven O'Clock by Igor Dvorkin, Duncan Pittock, Ellie Kidd and over 1M + mainstream tracks here go.lickd.co/Music License ID: 3WrnVD7Vrzd
#fishing #boating #boatmaintenance #rydlyme #saltaway #boatengines #boatengines #saltwaterfishing #flushingboatengines
#fishing #baoting
#mercury
#honda
#kawasaki
#evinrude
#yamaha
#boatengines
flushing boat engine
boat motor maintinance
#nw fishing secretes
#boat engine repairs
#salmonfishing
#rydlyme
#saltaway

Пікірлер: 14

@omcbob37 Жыл бұрын

Good video, but drop the needless music. Also would have been good to see how much crap got flushed out of the motor into the tub.

@steveperdueshowtofishingti2172 Жыл бұрын

Early production..lol..I now only do music at non talking scene's..and mostly in catching fish vids. As far as the stuff flushed out...it's all broken down and changes the PH of the water...you can't see it because it's so small after it's eaten away...which is a good thing. When you flush and the ph does not change it is not breaking anything down because it's all clean...this engine took over night..salt away doesn't work..it gums up thermostats and pop offs..

@youraveragefishkeeper Жыл бұрын

I watched all 3 parts. Really good info. I know many of us will find this very useful. Those internals are so clean I bet you can eat off of them.

@steveperdueshowtofishingti2172 Жыл бұрын

Lol..no doubt...I'm totally about testing stuff myself. Been doing it my entire career The results of salt a way vs rydlme kinda blew me away..I know so many including myself who buy and use it not knowing it's really not all you need...and a used motor you don't know the history on..no problem...compression check and flush 24hrs pH in is pH out is a dinner plate youbcan eat off..lol

@steveperdueshowtofishingti2172 Жыл бұрын

And thanks.

@roncaptain9527 Ай бұрын

I enjoy your video... As long as I mute the music... The music ruins your video ...

@steveperdueshowtofishingti2172 Ай бұрын

Yes, its been a whiles learning the sound and media combo, I watch this video and don't like the music either,lol, I may redo the video without, Its ok on intros, exits, or when I'm not talking, but this was an early video, I put music to everything.Thanks for feed back.

@denislaouenan5553 10 ай бұрын

Hi Steve, thanks for posting. The PH thing is clever. questions: 1/why do most recommend to remove gear case and connect to internal pipe instead of connecting to flush port? 2/ Once I am done with 1 motor can I re-use the mixed solution for 2nd motor or I need to start with fresh mix? I guess the answer is that it depends on how bad 1st motor was... Or same thing but in a more scientifically expressed YOU would say depends on what PH obtained when PH in and PH out became equal on 1st motor. last one/ should I do this as maintenance if I have no overheating even running full throttle for an hour in 87 F sea water or is this a curative procedure only. Thanks a lot!

@steveperdueshowtofishingti2172 10 ай бұрын

Hi, Thanks, some dont have a flush port and thats when you can remove gear bottom end, other wise I would use the flush port and take out thermostats if its available. 2nd ya PH would be off from the new, also if it went super high for a long flush its spent I would just get another, but if it barley changes use a bucket and keep using it as a maintenance every 3 or so months. if it was an older motor I would do it once a month to make sure it is all clean inside, but lets face it numbers don't lie, if the PH in is the PH out, its not eating anything away anymore so then its clean. 3rd, you could use it in a flush bucket every time at a 6 or 8 to one ratio and always have it cleaning your engines and never build up at all.. really depends on how long it has to sit without being rinsed after use as well.

@denislaouenan5553 10 ай бұрын

@@steveperdueshowtofishingti2172 Hi Steve, first of all thanks for replying so promptly, you know how it is, I thought of descaling my outboards and now I want it done yesterday, however I like to temper a bit and gather as much info as possible and your video was really informative plus you understood what you were on about. My motors are from 2006 with around 1000 hours. The build up is not too bad however there are cooling parts like the gas cooler that is not visible inside without dismantling. I got that boat 3 years ago, it was my working from home covid period project and I have done some good maintenance on it, I have put around 350 hours on it since I got it. Boat is on trailer, used almost every week end and motors are flushed running on ears with tap water every use.

@steveperdueshowtofishingti2172 10 ай бұрын

@denislaouenan5553 I would run a d rinse..just rinse when your done and the pH is down to what is in is out..especially older motors..

@eruditis 2 ай бұрын

Drop the stupid dumb noise over (music) We can't hear you speak...otherwise thanks for your effort, helpfull

@steveperdueshowtofishingti2172 2 ай бұрын

Haha, I have made many videos since this one.. I have lowered volumes if or when I do use it now. As well as type of video. This is a how-to video and most of them will not have music at all. Mostly in fishing under water scenes or fish on scenes. The point was and is definitely salt away won't be a cure all, and a flush with a. Acid style cleaner to flush is the best way to keep your engine clean. Thanks for feed back.