etec bottom end assembly
Рет қаралды 3,230
2 жыл бұрынTrue the crank and install, assemble the bottom end of the engine
@bretterickson8868 Жыл бұрын
Just watching to see the stator and flywheel install but the video cuts off, anyone else have this issue?
@kevinlaska5017 Жыл бұрын
Thank you for putting this together! I watch the splitting case too, hard to find a tutorial this good!
@Pneumamechanical Жыл бұрын
Thanks! I’m glad you found it helpful
@evangryba4665 Жыл бұрын
👍🏻
@MrDraftkid Жыл бұрын
Did you put 100ml of oil in where the water pump gear is? Thought I read this was something needed?
@Pneumamechanical Жыл бұрын
Yes, I pre-lubed it. I put quite a bit of oil in the cases. You have to lube the water pump gear after the cases are bolted together IIRC, has to be done in the right order
@MrDraftkid Жыл бұрын
@@Pneumamechanical you used just 2 stroke oil on gear and inside case I'm guessing? I just ordered a new pump for mine. the gear that runs of crank shredded. still debating on pulling engine to make sure debris isn't left inside some where..
@Pneumamechanical Жыл бұрын
@@MrDraftkid Yes just 2 stroke oil in the cavity
@MrDraftkid Жыл бұрын
@@Pneumamechanical Sorry, found the services manual. says 50ml of injector oil. Not sure if it makes a difference but wanted to correct myself. Thank's for the quick response.
@eastcoastguys5363 11 ай бұрын
What happens to the video at the end lol
@Pneumamechanical 11 ай бұрын
Sorry I’ll see what I can do, the editing program I was using was giving me issues
ТВ3 - сериалы и шоу
Рет қаралды 1,6 МЛН
Rocky Mountain Chainsaw
Рет қаралды 59 М.
vazovskie.official
Рет қаралды 2,3 МЛН
Анастасия Адаева
Рет қаралды 12 МЛН
Black Sea Trails | Zakhar Vernichenko | BikeLevel
Рет қаралды 770 М.