FIAT 500 Flashing mileage - Blue&Me Replacement

Рет қаралды 33,296

Жыл бұрын

Blue&Me replacement in a Fiat 500 to fix the flashing odometre, commonly used to indicate a fault in the electrical system relating to the car's recognition of parts.
#fiat #fiat500 #fiatpanda #panda #500 #odometer #odometercorrection #blueandme #blue&me #bluetooth #ctm #dtc #error #errorcode #garage #mechanics #cars #alfaromeo #uk #snapon #snapontools

Пікірлер: 22

@chrisadc3244

Great video. What a pain in the arse device to get out. Would have broken something through frustration and rage if it wasn't for this.

@Love500

None of them need to be coded. The sticker means you shouldn't need to do a proxy alignment if put into the same car it came out of.

@marksmith989

If you're doing an older 500 the first thing to do is clean the rear seat belt lower mounting bolt which comes out through the wheel arch. Wire brush and wd40. If you remove the bolt without doing this it will shear. Very very important to do this.

@richardparker9322 Жыл бұрын

Great video. Where did you send unit? I like the fact that no coding required.

@jaimecosta2966

What a estupidez pluce to plaxe a Blue me .. i have thesame problema with my fiat punto my life 2011 i have no ideia were the unit in placed here in Portugal it cost about 1000€ completly rediculess .. saying that excelente vídeo with you well

@kenoneill3642

I’ve sent mine for repair can I still drive the van without?

@Love500

Those seat belt anchor bolts have a tendency to snap unless you wire brush and lashings of WD40 on the end of the bolt in the wheel arch. You don't need to take the rear seat backs out either.

@johnpartlon8436

Where to buy you me unit?

@user-jx1ok5wp4w Жыл бұрын

Thanks for your helpful video. I have a Fiat 500. BLUE&ME causes the battery to drain. Is it possible to disconnect the BLUE&ME from the power supply, or do I have to disassemble the panel and disconnect the connector from the unit? Thanks.

@Livautowerx

Great video. I have flashing mileage and a battery drain as well as the blue and me not working. Can I just unplug the unit rather than replace? I’m swapping out the head unit but want the mileage to stop flashing and steering wheel buttons to work. Cheers