No video

FOR THE RECORD: EPISODE 1 Introduction to the Wood Glue Cleaning Method

  Рет қаралды 5,728

Brian Felber

Brian Felber

Күн бұрын

Пікірлер: 23
@stephaniezamora842
@stephaniezamora842 4 жыл бұрын
Love watching you ❤️ miss you so much
@SMALLFRYBRIAN
@SMALLFRYBRIAN 4 жыл бұрын
I miss you too my dear! We need a proper catch up soon
@HyperJp
@HyperJp 3 жыл бұрын
The spin cleaner in most cases would be enough to clean your records, what I do is use spin cleaner then listen to record, if its still sounds bad then wood glue it, for me about 80% of records i clean using spin cleaner don't need glue. But yeah the glue method does amazing job, just a very slow process.
@royrice6060
@royrice6060 2 жыл бұрын
I have never had a record in bad enough shape to try this.
@donovandownes5064
@donovandownes5064 4 ай бұрын
how can you pay the wood glue afterwards? wouldn't there be peaks instead of grooves?
@peterrech2307
@peterrech2307 3 жыл бұрын
if you put a few strips of thin card or stong paper on two to four equal points around the record it makes removal of the glue much easier.....
@peterrech2307
@peterrech2307 3 жыл бұрын
do this while glue is wet...
@ludwigfan3013
@ludwigfan3013 3 жыл бұрын
I wish I would've watched your videos first on this method. I used Titebond original wood glue but it dried brittle and now I'm scratching my records all to hell just getting it back off. I don't know if the premium is a better choice for this but I more than likely won't be doing this on any other records since it didn't go well the first time.
@graemehinde
@graemehinde 3 жыл бұрын
Hi! I tried this, but my results were disappointing. I used elmers wood glue because that’s what we had around the house, could that have been the problem? The application process went well, but then it took over 24 hours for the glue to dry, and even then it still had some pasty spots; the peeling process got a little messy. The main disappointment came when I tested the record: it did not sound any worse, but it did not sound any better either. It’s an old record, and it had (and still has) lots of surface noise, consistent from start to finish. I was pretty sure the noise is caused by grime and not scratches, which is why I thought this would work. Is it possible it might go better if I get some titebond and try it again?
@graemehinde
@graemehinde 3 жыл бұрын
Update: I tried again and achieved much better results! Seems like the first time I used too much glue. Next time I laid a thinner layer; it dried a lot faster, maybe five or six hours, and the surface noise was dramatically reduced. Great stuff!
@JnL_SSBM
@JnL_SSBM 2 жыл бұрын
3:36 Coldplay - Daddy (Backwards)
@PapaBearsStudio
@PapaBearsStudio Жыл бұрын
For the love of God.... Don't use a credit card. Just fold a paper towel till it's about an inch wide. You'll NEVER damage the record that way. Less mess too.
@digidoridvideos3672
@digidoridvideos3672 11 ай бұрын
V1NYL $N0BZ Moments.....
@vibefrequencyable
@vibefrequencyable Жыл бұрын
cant seem to get the glue off... did one side of the albums perfectly then switched sides.. same process kept the house at 64 degrees and cant get the glue off... seems to have boded super tight...made paper tabs and they just ripped off???? get a hairdryer or what?
@SMALLFRYBRIAN
@SMALLFRYBRIAN Жыл бұрын
Hi Lionel! I'm so sorry to hear that happened to you! May I ask, what type of glue did you use? I would suggest using a hairdryer over the record for a few seconds just to soften up the glue, you should be able to peel it back afterward.
@vibefrequencyable
@vibefrequencyable Жыл бұрын
@@SMALLFRYBRIAN just regular water soluble titebond 1
@SMALLFRYBRIAN
@SMALLFRYBRIAN Жыл бұрын
@@vibefrequencyable Perfect! Definitely try the hair dryer first. Hold it about 12 inches away from the record and just use the low setting on the dryer to just warm up the glue. After about 10 seconds or so, you should be able to peel it back.
@vibefrequencyable
@vibefrequencyable Жыл бұрын
@@SMALLFRYBRIAN i will give it ago.
@SMALLFRYBRIAN
@SMALLFRYBRIAN Жыл бұрын
@@vibefrequencyable If you haven't seen it already, this video is all about removing the glue. There are some extra tips in there that might help you with your record to get the stubborn glue off.
@onefatstratcat
@onefatstratcat Жыл бұрын
Use the Spin Clean.. save a horse :)
@PapaBearsStudio
@PapaBearsStudio Жыл бұрын
You use way too much glue too
@PapaBearsStudio
@PapaBearsStudio Жыл бұрын
Pre washing is a waste of time
@andrescadabid3022
@andrescadabid3022 9 ай бұрын
This gotta be the dumbest way to add to the process to clean plastic acetates vinyl records. do not do this BS. This guy probably hates his records … trust the source guys… why would anybody lie to you ???
FOR THE RECORD: EPISODE 2  Cleaning your jackets & repairing spines
11:03
Can Wood Glue Beat Specialist Vinyl Record Cleaning Products?
16:38
а ты любишь париться?
00:41
KATYA KLON LIFE
Рет қаралды 3 МЛН
Чёрная ДЫРА 🕳️ | WICSUR #shorts
00:49
Бискас
Рет қаралды 4,9 МЛН
Happy birthday to you by Tsuriki Show
00:12
Tsuriki Show
Рет қаралды 10 МЛН
Spin Clean Vinyl Record Washer: The good, the bad and the ugly!
15:02
How to Clean Vinyl Records with Wood Glue
13:59
GR& Design
Рет қаралды 3 М.
Cleaning records with wood glue, does it really work?
11:06
viperfrank
Рет қаралды 204 М.
Cleaning a Record with Wood Glue!?
8:07
The Fixer
Рет қаралды 77 М.
The 45rpm Record
21:44
Fran Blanche
Рет қаралды 255 М.
Using HOUSEHOLD PRODUCTS to clean vinyl - haters gonna hate!
18:05
PW Restoration
Рет қаралды 10 М.
What You Need to Know About Glue | WOODWORKING BASICS
9:37
Steve Ramsey - Woodworking for Mere Mortals
Рет қаралды 1,7 МЛН
I Tested One Of The Cheapest Vinyl Record Cleaning Machines
12:30
Andrew Dixon
Рет қаралды 32 М.
Vinyl Record Cleaning - STOP NOW!!!
6:48
Scientific Audiophile
Рет қаралды 114 М.
FOR THE RECORD: EPISODE 6   Peeling the Glue & Rinsing the Record
10:31