Ford Transit Van Build | Dry-fitting Panels|Structural Steel & Flare Trim Ring Attachment

Рет қаралды 1,049

Жыл бұрын

As we start to work on ceiling and wall panel preparations, we discuss two things in this video:
➡️Titan Vans Structural Steel Assembly Kit: Creates a clean finished look for wall and ceiling panel junctions. This kept us up lots of nights trying to figure out how to land the wall and ceiling panels until we found this solution!
Link: www.titandiykits.com/products...
➡️ Flare Trim Ring Placement: How to measure and attach trim ring to plywood to cut opening for flares.
Follow us!!
➡️Facebook: BlazingWanderers Page
➡️Instagram: @BlazingWanderers
➡️Website: BlazingWanderers.com

Пікірлер: 2

@jeffsgarage8414 3 ай бұрын

Can i ask why you chose to use titan’s structure kit but then use avc vans panel kit rather than just go with titan everything? I’m Looking at this option too because i value time over saving a few bucks figuring it all out myself, which may take months

@blazingwanderers 3 ай бұрын

Hey there! At the time, I am not sure if we even looked at the Titan wall panel kit (we purchased in 2021). It was when we starting framing out the van with the wall panels that we realized we needed the structure kit if we wanted our wall panels to meet up with no gap. My husband was very active in the FordTransit Forum online and I believe this is where he learned from someone else about the structure kit. It does make the wall panels and the ceiling panels fit together perfectly, and if we did it again we would still use that kit!