Friction machining on the lathe, is it worth it?
Рет қаралды 4,442
Жыл бұрынHi guys, I made this video to show that it is not always possible to obtain valid results on the first try... If we consider this type of processing, it is possible to work well with thicknesses no greater than 2 mm and diameters no greater than 40 mm.
I hope you enjoyed the video, if you want to stay up to date, subscribe to the channel and put a like!
THANK YOU
@Massimo68ac Жыл бұрын
Normale procedere per tentativi! Lo speciale è perseverare e fare il risultato, come lo hai ottenuto tu! Complimenti👍👍👍👍✌✌🤗🤗
@lucasandri5462 Жыл бұрын
Molto interessante, bel video!
@Masters.of.101 4 ай бұрын
How is it possible to draw 18 gadge stainless-steel pipe if it is possible to draw please make a video as possible by the way nice work dear
@claudiovandoni7878 Жыл бұрын
In ritardo ma bravissimo come sempre
@user-mq8uv9zq3x 3 ай бұрын
Very nice video and technique. I wonder if the tube was pre-heated with oxygen- fuel torch if the tube seam stay intact.
@newtech5042 3 ай бұрын
Hi, I didn't preheat the tube, the friction of the tool is enough. As far as welding is concerned, these pipes are actually difficult to work with (not counting the galvanization), it is much better to work with non-welded pipes.
@user-ys7qf6vc4p Жыл бұрын
А чем Вас самокал не устраивает? - и да, - для таких целей, резец ставиться выше центра!
@lucasandri5462 Жыл бұрын
Molto interessante, bel video!
Chill TheSoul Out
Рет қаралды 22 МЛН
Vilson Alba
Рет қаралды 334 М.
Smart Appliances!🤩 Tool Items, New Viral Gadgets, Kitchen Utensils /Home Inventions #shorts #gadgets
The Technical Sultan
Рет қаралды 8 МЛН
Santi Oficial
Рет қаралды 26 МЛН