WOW that was a lot of pulls on the engine

You could put a couple of washers between the wheel and the hex

HaG i can't figure out why everyone Don't just pour a bit of Fuel in before trying to start it up.that way you have instant lubrication and dont look you're wacking off the Nitro 😂😂😂 if it doesn't stay running then it Answer's questions for ya immediately 😂😂 etc. Etc.😂😂😂

This reminds me of why I do not own any pull starters bro you have hands of steel nice work bro keep it up 🤜💯💯🇦🇺🫡

Great video mate. I sent you a part number for an upgraded cheap pipe for that lovable carnage. As always 👍💯👊🏻love the video. 🙏 for helping keep Nitro alive🤙😝❤️👍🤘🔥👊🏻

nice little video

I just got one of these FTX carnage and the wheels are so wobbly. Would be nice if the drive shafts were a better fit in the bearings.

I love your channel bro. Your a energy being full of happiness and cheer. Keep it up bro 👍😀

I always take at least 2 nitros with me you never know when one will take a crap

I just got a 3rd new motor on my 2021 jato. I replace 6 motors

They're not bad those wee things.... The bodyshell's are a bit brittle though.,

heya haggard rc i went for the Zorro exactly the same on the inside just a litte smaller wheels {and arms i think) had to get the grey bit for the ehxast too only thing my bell end gets well hot haha

Maybe you can put a racing engine in there but then the question is: Will the rest of the truggy survive this? I am asking myself the same question cause i am doing a little engine upgrade as well in my 1:8 Buggy ;) but i wouldnt go too far with these mods because otherwise its too bad to drive it (cause a lot of work and money went into the project - like with my Arrma Krapton ) p.s. i like to prime my engine with my finger on the exhaust cause it started with only 3 pulls

can you do a vid on the starter box you have and how it works for Nitro please mate, does it work with the carnage which is similar to the ftx Torro/zorro?

I have a idea for more air How about a turbo of some sort use a fan to blow air in👍

shame about the engine mate. just been shredding some dirt with my buggy, i did put a clip up on social media if you can see it i dont know. as for the float order fluxed aluminium rods 20 for about 3 quid. they will fix it for sure

mm to bad man , maybe re pinch the sleeve woud be nice video to see if it works , with heat gun and jubilee clip 👍😉

U can get nitro rustlers gray hex nuts there wider

HaG i know exactly what you're talking.i did Small engine repair work for 7 straight yrs.replaced many of those floats. They went to plastic style.those Brass ruined alot of Engine's.flood the crankcase full of gasoline and if it would started and ran it was done for 😂😂😂.i always check oil and smell it to make sure no fuel is in Oil!! That brought back memories and nightmare s for me 😂😂 what is your other channels name?? !!

You need a new motor now

Thats a brass flot Haggard try and solder the hole then you will have a extra.

Rusty I have a brand new engine sitting in a box for that exact truggy

Hey send me your address i will send you one. S pipe. Its a little used like a quart of fuel but it looks and sounds nice for a .18