Honda Accord How To Fix D Light Flashing P0962 P0966 P0970 G151 ground location

Рет қаралды 2,917

4 ай бұрын

In this video we show you how to repair your G151 ground issue that can cause your transmission not to shift properly, cause jerking, the d light to flash while driving and would also cause the engine light and abs light to go on with codes to the transmission pressure solenoids and abs unit. Good luck and hope this helps!

Пікірлер: 12

@redfoxgarage9660 2 ай бұрын

Big thanks, I had a P0970 code and this ground location was the culprit. This could have taken me forever to find without this video.

@acetechauto7 2 ай бұрын

I’m glad you came across this video and were able to fix the issue as most places would’ve probably tried to sell you a transmission.

@ricardocenteno375 Ай бұрын

I might have the same problem I’m getting a po 798 I tested the selenoids manually with a battery they all work

@acetechauto7 Ай бұрын

Most likely you have the same problem very common issue on that ground wire

@ricardocenteno375 Ай бұрын

Thanks buddy

@acetechauto7 Ай бұрын

No problem!

@nolannorminor66 2 ай бұрын

Thank you so much

@acetechauto7 2 ай бұрын

No problem glad it helped!

@nolannorminor66 2 ай бұрын

Do you know where I could find a replacement g151 metal bracket, idk if you made your own substitute or bought a new one. I just don’t know what to call when searching in google to buy one.

@acetechauto7 2 ай бұрын

I’m not sure you’re gonna be able to find that anymore due to the age of the vehicle your only option might be a junkyard. I just made my own

@dexiaoli7728 Ай бұрын

Hello, my friend, my 2007 Odyssey has P0962 and P0970 fault codes. At that time, the control circuits of the gear solenoid valves A and C were too high. After disassembling, I found that the wires of A and C were broken. After replacing them, P0962 and P0970 fault codes appeared again. Now I can't find out where the fault occurred. Please tell me how to repair it! Thank you

@acetechauto7 Ай бұрын

Hi you would have to test the wiring and see where you have a broken wire and once you get that repaired you should be good to go.