Thank you for the video. It worked for me, even though my plug had two additional wires than what your video showed. The positioning of the two wires needed in the plug are the same.

For me There was a strange looking tab on the red connector, I just had to push really hard and pull really hard on the connector. This method worked well and may have even cleared a live valve code at the same time, not sure as I did try a different method for the live valve just before doing this, but I assumed it did not work, but after this method, the light was off. Thanks a million 864 Offroad LLC, I could not have done this without you.

I tried with a 2018 sxs 1000 honda pioneer and it worked its a red conector under the seat with a green paint Mark ... Thank you

I appreciate the shit out of this video bud! Helped me out.

🏆🏆🏆👍🙏 Subscribed Thank you for sharing

Worked for me thanks 👍🏻

Awesome thanks!

I have a 2021 Talon X. I don't have the same red connector to jump out with the wire. Am I missing something or is it different on a 2021? Thanks.

Thanks much appreciated. This video is really informative but for the life of me I can not separate the red connector to add the stiff wire. How does the connector come apart, I hate to break this thing.

Hold the brake Turn on key When the light goes off let of brake When it comes on press the brake again It will go off again Let of the brake again It should blink 2 times

i also have a 2021 x and the red connector does not have wires to jump on that side of connector,,, please advise

Jumped across the 2 wires shown but my I4wd light won’t go out.

Is the plug different on a 21 1000x4 or in a different location? The one under my driver seat is a 6 pin connection.

I have a 2021 Talon. I have 27 miles on the unit which just spent 4 weeks in service to replace a solenoid in the front causing the I4 indicator to come on. We literally drove it for 2.5 hours and its been in the shop ever since. I finally picked it up Tuesday and now the AT/MT indicators are both lit and I can't turn one or both off with the toggle switch? Any ideas? Does the lemon law count for these types of things? I think I have a lemon......

I can’t get the plug to come out of the cap! And NO where shows you how.

I have a 1000x4 and could not locate that red plug

After u reset it, can u take your wire out?

Anyone else see the BIC lighter down there.