How to change Mitsubishi Triton/L200 brake pads, disks and calipers.

No video

How to change Mitsubishi Triton/L200 brake pads, disks and calipers.

Рет қаралды 24,018

Күн бұрын

Today I show you how to replace the pads, disks and calipers on a Mitsubishi Triton/L200, While it isn't a complicated job it is a bit time consuming and is a lot of work just to change disks. however here i show you exactly how to do it.
All the parts to replace the brakes came from Milners off road www.milneroffroad.com
Disclaimer: Due to factors beyond the control of Chris’ Man Channel, We cannot guarantee against improper or modification or use of this information. Chris’ Man Channel assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Chris’ Man Channel recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Chis’ Man Channel, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Chris’ Man Channel.
#truckbuild #L200

Пікірлер: 9

@cainanashton 2 ай бұрын

Good vid bro, now I am brave enough to give it a go.

@beth8186 4 жыл бұрын

I’ve been able to change my discs and pads with ease and confidence thanks to watching your video, it’s saved me a fortune at the garage. Which will mean I can buy new calipers sooner and strip the truck back down again 😂 thanks for making my life easier! X

@N269 3 жыл бұрын

I admire your video.... just did one (Aug 28 2021)... and this was quite helpful. Thank you. I found no deviation from your disassembling than that what I experienced. Gotta give you 👍👍

@andrewhelmer7710 2 жыл бұрын

Excellent video . Very brave to tackle this repair by the roadside but I would not rely solely upon the trolley jack without axle stands or some blocks of wood to help prop up the vehicle. These ABS rings and sensors on this model are far too exposed and vulnerable to dirt and damage. I believe the newer models have a better design and are much more enclosed so not so vulnerable to dirt or damage. Beware when buying a used Mitsubishi L200 with these type of ABS rings especially one which has had a vehicle lift done by a previous owner which might have also damaged the ABS sensors and leads . Some unscrupulous people remove the ABS warning light from the instrument cluster to hide faults in the ABS system. The ABS light should always briefly come on when turning on the ignition if it does not then it will be an MOT failure provided the inspector notices it.

@lupingreybeard5990 Жыл бұрын

Thank you so much for this video! quick question at 16:00 you removed the 6 bolts (14mm I think) , what are the lengths of those bolts as all mine have been sheared (can't unscrew them from the front)