Paul Hagiantoniou shows how to install the new Eemann Tech competition disconnector for CZ Shadow 2. #eemanntech #ipsc #czshadow2
Пікірлер: 20
@wiederladerTv3 жыл бұрын
Nice...hope you produce such a disconnector for the CZ P-09 Duty in future also.
@Blakehenry113 жыл бұрын
Great video, man you did that fast.
@cx4gunman3 жыл бұрын
Thanks! Again a great video.
@paulhagiantoniou5303 жыл бұрын
Thank you
@aarmleif3 жыл бұрын
Great Series so far. Can you tell why there isn't no other trigger for DA? I got short fingers and would like to change something.
@fabrizioverrastro28973 жыл бұрын
Good morning Mr. Paul I have installed on my Cz Shadow your "competition disconnector" following exactly the instructions as shown in the video. However, I have noticed, once the gun is assembled, that the trigger bar "Trigger bar" hesitates to engage and therefore before pulling the trigger, you hear a noise like a "tick" but then everything works regularly. Can you tell me what could be the cause of the jam. Thank you
@nskitedude25123 жыл бұрын
Hello, I'm looking at your Ultimate trigger or flat trigger for my Shadow 2. Should the disconnector be used with them or is it intended for the stock trigger ? Will any of these items increase the trigger pull weight or affect primmer strikes ? The only changes I made to my old Shadow was a 13lbs main and a 11lbs recoil. Virtually no light strikes using hard primmers so I don't want to loose reliability. Cheers
@paulhagiantoniou5303 жыл бұрын
Hello, yes use the competition disco! It’s intended for the stock trigger and the flat and the new ULTIMATE. The choice of trigger you use has no consequence on reliability regarding primer ignition.
@paulhagiantoniou5303 жыл бұрын
Changing the trigger will not increase the weight of the trigger pull
@ehteshamy2k Жыл бұрын
Hello, I have installed competition disconnector in my CZ 75 SP-01 Shadow and have already installed competition springs. After installing the competition disconnector, the trigger works as expected in SA but the trigger became hard in DA. Is it a normal behavior?
@Skeetersbuzz Жыл бұрын
I have a question: i want to buy some of your parts here in the US. Where can I get them? Also, o want to put a brass trigger in my Shadow 2 and convert it to SAO. Do you have a brass trigger that I can use to do that with?
@dmitrieemann Жыл бұрын
you can check our USA dealers on www.eemann-tech.com/dealers/
@dmitrieemann Жыл бұрын
for SAO we produce only aluminimum triggers
@Skeetersbuzz Жыл бұрын
@@dmitrieemann ok, so where can I buy your SAO black trigger and thumb rest slide stop for a Shadow 2 in the USA?
@nikossinos11402 жыл бұрын
Hello , I have just ordered eemann tech upgrade kit for cz shadow 1 ,but I have a problem putting the new disconnector. The pin of the disconnector does not move. I think that is pressed in, hammered in . What shall I do?
@dmitrieemann2 жыл бұрын
yes, from factory its pressed in, if you cannot remove it, follow to gunsmith
@rollyipsc3 жыл бұрын
Do you have one for tanfo stock2 xtreme?
@paulhagiantoniou5303 жыл бұрын
Indeed we do Mate Product code ET-152010 Check pricing and availability from your nearest dealer