Thanks for the kind words! If you'd like to apply to become an ExoShield installer check out this link - www.getexoshield.com/exoshield-partner-application

We have some installers in our network that have tested out the 2 heatgun method in a few different variations! In the end, ExoShield GT3 moulds well enough with one that having a second is more of an inconvenience. Sounds like you know your way around window films! Our of curiosity, have you worked with any windshield protection films specifically?

@@ExoShield It's a really tough sell here in South Carolina because law requires insurance companies to replace the glass for free since it's considered a safety item. Other than the occasional rare old-school window or an exotic, I can't find a single customer for it. I've tried. But I do still love to watch these videos and learning new techniques.

We completely understand! In some places like Arizona which has a similar replacement situation, our partners have been finding great success with customers that are trying to avoid these claims hitting their insurance. With the average cost to replace climbing up over $1000 windshields are becoming too costly to keep covering under the antiquated policies that were built around $100 replacements and no calibration. Linking up with a local glass repair shop is another great way to educate people about the need for windshield protection at the source. If you have a glass shop that is focused on creating a great customer experience, theres a good chance they would be interested in protecting the freshly replaced glass! @@autostyleonline

Hey David! If you'd like to connect with our team about installing ExoShield GT3 we would suggest filling out our Partner Application. Thanks for reaching out! www.getexoshield.com/exoshield-partner-application

Once cured, ExoShield doesn't have any distortion! Wiper chatter is not something we notice normally with protected vehicles and yes there are some hydrophobic properties to ExoShield. Thanks for asking!

900-1000 Fahrenheit is usually what we suggest heat guns be run at. You need a heat gun that moves a lot of air as well (high cfm)

IPA is used to clean the surface of the glass to remove any coatings or contaminants!

@@ExoShield OK perfect. So I don’t need to apply any IPA before I am going to apply the film onto the windshield?

Only for a final clean before application! There is no need to promote the adhesive with IPA like you might with other types of automotive film. @@NoName-bi7lz

Hello! We sell this film strictly to our partnered installation network. Visit this link to apply to become a partner and start offering our products! www.getexoshield.com/exoshield-partner-application

While the model Y is a difficult installation it is absolutely something our installers are capable of protecting!

I think a similar video with instruction for Tesla y will be more than welcomed. Thank you

@@radudumitriu5163 the methods taught in this video are exactly what would be used on the Model Y! We chose to use a Model 3 for this demonstration because it is a highly curved windshield and the process needed to form ExoShield GT3 to the Model 3 glass can be used on any vehicle.