A viewer asked about some more fastener related videos in the comments - and I finally got round to it! How to set solid rivets. (AN470) (MS20470) This is a quick look at two widely used methods.
Пікірлер: 14
@spencerwilmot24492 жыл бұрын
Really helpful. Thanks! This was my intro to rivets/ing. A lot more than I expected, I'll be honest.
@ramyihtzhak3 жыл бұрын
Thanks a lot for your lesson. It was cristal clear. You got a new subscriber. Best regards from Colombia / South America.
@framavia22013 жыл бұрын
Thanks for the sub!
@aryanyadavkshatriya44474 ай бұрын
Very good information sir with good audio and video
@HellFire1073 жыл бұрын
Audio came across a bit quiet but I could hear you when I maxed out my laptops speakers so that's good enough. Excellent work and demonstration! This will be quite helpful to me as I have never used these tools before and have a structures lab tomorrow focused on riveting. Thank you very much!
@framavia22012 жыл бұрын
Good to know!
@jtveg3 жыл бұрын
Old Cessna probably needed a new skin anyway. Lol. Thanks for sharing. 😉👌🏼
@2hotscottpro Жыл бұрын
Part 2 would be nice.
@janier1244 жыл бұрын
cant hear you
@ippielb4 жыл бұрын
Will a solid rivet be able to fill an oblong hole? It’s on a snowmobile. The blind rivets relaxed and the hole was egged out a bit. Was wondering if a solid rivet would be able to expand in the hole to take up the slack.
@framavia22014 жыл бұрын
It will expand a little, but the correct thing to do with egg shaped holes is to make them round again and use an oversize fastener, providing you have enough edge margin.
@ippielb4 жыл бұрын
Fram Avia there is not very much edge left. It is a single row of rivets along the edge of the snowmobile tunnel that’s made from Aluminum. I’m concerned if I drill it out to another size larger the holes will rip open.
@bojjeeyz Жыл бұрын
Hallo kalo part untuk mengatur angin di rivet gun itu apa namanya ? Aku rusak dan ingin membeli tp gatau namanya hehe