Great video, you just saved me $40 by only having to buy the Spur Gear.

Showing how to set the gear mesh (not too tight, not too loose) was very helpful.

Great video and thanks very much. I am 68 years old with a new Arrma Vendetta (love it lol). I learned alot from your video.

Super super helpful. I ran my brand new Vorteks 3s straight into concrete at almost full speed and got out lucky - broken bearings on the slipper clutch, bent motor plate, and the feature part of the video a stripped spur gear. It was a total relief to just get it going again... this video helped make it happen. I'm excited to get back to bashing. Thank you very much for being intentional, slow, and descriptive of how this needs to go back together the proper way, from a newcomer.

Phenomenal explanation…thanks! About to install the metal spur gear on my son’s Typhon 3S!!

You done a very good job just what I needed to see thank you. S.C

Nice mr philip I always have this problem and my dad is busy so now I know how to do this on my own 😎🏁

This is an amazing quality video and I really needed it because I am a noobie to rc

Really good and well edited video but I absolutely hated the music I think you could do without it but if you insist on it turn the volume of it down 50% or more from this video. Thanks for the help with the spur I had no idea what I was don't

Cool Beans !! Now I know how to GIT ER DUN !!!!

Thanks brother use this to change out my gears just subscribed

Awsome explaining

Nice walk through probably the best one I've seen on here. SUBBED!

Can you send the link on where to buy this power tool?

This was the exact car I was looking this up for lol. Pimpin

Nice video. It was a little hard to hear you because the music was a tiny bit too loud. Good job though 👏 👍!

will this work on a typhon v5 and so what add parts will I need

My arrma is a stock 2s NiMH 4x4... Whats the best way to upgrade to a 3s Lipo? Do i have to get a new ESC And moter? Besides just the 3s Lipo and new charger...

The spur bearing was really hard to get out of my old gear and had to be tapped into new gear. Yours just popped out lol

it looks like it has 3 cluch plates is that correct?

Thanks, got the new spur in but when the car goes slow its fine but when i hit the throttle it pops sorta, brand new pinion, and spur, idk why

Well done, brother. New to RC, and this happened. What type of driving causes the spur gear to get rounded off on the tips? Thanks so much.

I Cant take apart the spur gear because it seems to me that the senton is different from yours

Man Ive done the spur rebuilt the slipper.. rear diff not the front diff and replaced the bearings in the transmission.. I cannot for the life of my figure out what is slipping . I can slam the brakes from full no issue no slip.. of ground and rev the shit out of it and its absolutely fine but from launch its screaming.. the transmission sounds perfect to me.. the diffs are working fine and aren't slipping.. to me it has to either be a broken motor somehow or they'res something wrong with the slipper I didn't pick up on... Driving me nuts took me ages to source the parts 😆

How come you not upgrade to metal spur

How can you tell if that center screw (1.5 turns out) is too tight or too loose?

Seems it would be easier to take the drive shat off before prying the motor out ? Maybe not ?

Note: you should be able to put a piece of paper between the gears due to Plastic expanding when rotating.

Wish there was no music, so I could actually hear what your saying 😢

My gear just keep getting Loose and it does spins