How To Replace Front Brakes on Audi S5 B9

Рет қаралды 18,277

Жыл бұрын

Replacing the front brake pads and rotors on an 2018 Audi S5 B9.
This is a DIY video assisting you in replacing the Audi brake pads and discs whether you want to upgrade or simply need to replace.
Disclaimer: This video is for illustration purposes only, any work you carry out yourself on any vehicle is at your own risk!
Audi S5
Audi A5
Audi RS5

Пікірлер: 26

@coalieroller5663 Жыл бұрын

Audi does say remove the 21mm bolts to remove the bracket and caliper instead of the special bolts to do a brake job. Good job

@Adubs808 Жыл бұрын

thanks for this. need to do my brakes and nervous but will be rewarding

@gamechanger8382 5 ай бұрын

Great video just did mine using your video. Question is there only one brake wear sensor on the front ? Job was much more involved compared to my 996 Porsche. Rather fiddle to be honest but got it done. Caliper hardware was the most difficult but once I figured it out the other side was a breeze relatively speaking.

@darkspeed62 Жыл бұрын

Seems good, and fairly thorough. The only thing I would say is that you forgot to mention torquing the caliper bolts to the correct torque spec, and possibly adding some thread locker paste to the bolts as they're going to be prone to vibrations so wouldn't want them to work loose!

@EAPerformance Жыл бұрын

I’ve been a qualified mechanic & performance specialist for 14 years. You don’t need to worry about thread locker on any bolts around the braking system, if you look at their washers on the bolt you will see they are grooved, these are vibration proof washers. I’ve been doing this long enough to not worry about torque specs on items like this. How tight it felt undoing the bolt, do the same type of tension when doing it back up. If you’re unsure, then use the torque spec

@MacDamera 4 ай бұрын

What's torque specs

@mova_2020 2 ай бұрын

How hard is it to also do a clean job when doing this? Like thoroughly cleaning that super dirty caliper? Inside was like a disaster. Does it cost more to do a clean job? Or is it all the same?

@ax23xr Жыл бұрын

hello. great video breaking down step by step. does this process also apply for a 22 s5 Sportback?

@EAPerformance Жыл бұрын

Yes it does

@rs3tuber425 3 ай бұрын

Did you guys torqued the bolts?

@yrichard6404 4 ай бұрын

May i know brake pad model and part number along with the rotor tks

@as5950 Жыл бұрын

Love this. But do you have to bleed the calipers once you are all done? Planning to do this next weekend on my S5

@EAPerformance Жыл бұрын

No need to bleed, because you haven’t let any air into the system you are all good. By opening the nipple to push the piston back it is essentially bleeding it anyway

@as5950 Жыл бұрын

@@EAPerformance much appreciated. I actually followed you video to the tee. Used OEM pads (yea I know I’m just OCD like that). Zero issues. And car stops on a dime. Thanks again!

@mozerul1 Жыл бұрын

instead of bleeding the brakes , can i use obdeleven to open the calipers and close them once the new parts are in ? Cheers

@EAPerformance Жыл бұрын

HI, that is only for the rear brakes because they run an electric handbrake. The fronts dont have electric motors. But you will still need to push the piston back even after winding the motor back with your scan tool, so the bleed method is still needed.

@PhatBoyiee 10 ай бұрын

Do you have any break replacements videos for 2021 audi s5 b9.5?

@EAPerformance 6 ай бұрын

If i get one in i will make one

@craighunter1682 Жыл бұрын

Is this the same process for an 18 plate A4 Avant?

@EAPerformance Жыл бұрын

Yes exactly same process

@robp696 7 ай бұрын

Didn't need to use brake cleaner on new rotors? Edit- Ahh I see you did mention it at the very end of the video.

@joshsheinis5968 6 ай бұрын

Interesting… In the Audi manual they instruct you to retract the caliper and push the fluid back into the reservoir

@EAPerformance 6 ай бұрын

Never ever do this on an ABS car!! It’s bad practice. If you have a chance to extract old deteriorated fluid, do it. The worst section of fluid is going to be at the caliper

@joshsheinis5968 6 ай бұрын

@@EAPerformance I wonder why the engineers over at Audi decided to not include that in the service manuals. They just say retract the caliper, they even go as far as saying to extract brake fluid from the reservoir if it is full because it could overflow when you push the fluid back

@EAPerformance 5 ай бұрын

@@joshsheinis5968 engineers are useless half the time. Look at some of the places they put components which should be simple to replace but then make you remove the entire engine to do so.

@joshsheinis5968 5 ай бұрын

@@EAPerformance Yes, but, they were the ones that designed the components after all. As well as took the time to write out step by step repair/service manuals for dealerships to follow. So I would like to think they would not instruct you to do something that would damage the vehicle