No video
How To Replace Transmission Oil Cooling Lines [ Chevrolet Cruze 2011-2016 1.8L ]
Рет қаралды 6,046
Күн бұрын🔴 Subscribe HERE ! www.youtube.co...
💙 Donation Support The Channel www.paypal.com...
🛠Tools:
🔸Long Pick Set amzn.to/33jOkCO
🔸Cordless Ratchet amzn.to/3tCIpRI
🔸Basic Socket Set amzn.to/3aUtPwk
🔩Parts:
🔹Transmission Cooling Lines amzn.to/3fm7vON
@yulla22 2 жыл бұрын
I've been waiting for this video thank you so much
@patriciamontgomery4274 4 ай бұрын
Thanks!
@OneTrickTech 4 ай бұрын
@patriciamontgomery4274 No problem! Thank you for the donation. Glad my video helped you !
@white0moon 2 ай бұрын
2016 is the second generation, with the battery in the trunk.
@Sabs761010 6 ай бұрын
My cruze 2011 beging to leak from the top base of cooling line(part that you tight at 14:30 minute), what could be the problem? Could be a over filler issue?
@patriciamontgomery4274 4 ай бұрын
My 2011 cruze has a trans cooler separate from the radiator. Do you have a video on replacing the trans oil cooler in the 2011 chevy cruze?
@OneTrickTech 4 ай бұрын
@patriciamontgomery4274 I believe you have the 1.4 turbo engine. All my videos are for the 1.8 L engine sorry !
@queenjaderenee4838 7 ай бұрын
Which hose is the shorter hose directly under the battery?
@OneTrickTech 7 ай бұрын
outlet hose
@TheKhwailed Жыл бұрын
Which line is the inlet to the radiator? Is it the bottom one or top one?
@OneTrickTech Жыл бұрын
top
@yulla22 2 жыл бұрын
How did you know how Much trans fluid to put in?
@OneTrickTech 2 жыл бұрын
I just added a bit of fluid because when I removed the bottom line, some fluid came out. I will be doing a video on transmission drain/fill and how to properly check fluid level
@yulla22 2 жыл бұрын
@@OneTrickTech what would you rate the repair out of 10?
@christopherrose6986 Жыл бұрын
@@skidooer58371" inch lbs is the correct fastening torque spec per GM
@Sabs761010 6 ай бұрын
How much did you tighten the connector at 14:30 minutes? because mine is leaking
@OneTrickTech 6 ай бұрын
@Sabs761010 I tighten by hand once the nut is bottomed out. If yours is leaking make sure both surfaces are clean and flat so it can seal correctly
@Sabs761010 6 ай бұрын
Does the sourface must to be dry or does not matter that it has transmission oil?@@OneTrickTech
@OneTrickTech 6 ай бұрын
@@Sabs761010 dry no oil
@Sabs761010 6 ай бұрын
@@OneTrickTechcan I put it silicone to the connector because is leaking?
@OneTrickTech 6 ай бұрын
@@Sabs761010 you can try to put gasket maker. if it doesn't seal, i believe it can be a faulty cooler line
@Kens902 7 ай бұрын
My transmission cooling line is twice as long and goes in to the radiator on the opposite side of the car 🤦♂️
@KINGRG1 Жыл бұрын
Was removing the front bumper necessary?
@OneTrickTech Жыл бұрын
I removed the bumper for filming purposes. You might be able to reach the lower line without removing the bumper, but its a very tight fit. Its an extra step but it will give you so much more room to work with.
@eddiesgsr Жыл бұрын
What about for the sonic can it be done with the bumper or will the job be easier removing it
OneTrickTech
Рет қаралды 78 М.
Дима Масленников
Рет қаралды 9 МЛН
Андрей Флорида
Рет қаралды 97 М.
Wrenching With Kenny
Рет қаралды 124 М.
Mark Jenkins
Рет қаралды 617 М.
Moose Mobile Auto Repair
Рет қаралды 10 М.