how to revive a hoverboard batteries that won't charge 🤔

Рет қаралды 21,732

2 жыл бұрын

Пікірлер: 14

@bostondellman 2 ай бұрын

Worked for me BUT I was really kind of surprised with the size of the spark that woke it up, I took a line fight off the Negative charger wire. I have also found out that after doing it the 36 volt charger still woud not kick in so I tried a 24 Volt Razor brick with the same connector and it showed red and after I left it on for about 10 Minutes and switched back to the 36 volt charger it worked. Thanks for the negative shuts things down tip .

@ChayBode 6 ай бұрын

This has worked for my battery, thanks. :)

@rouenwucherpfennig2524 3 ай бұрын

You're welcome! Glad it helped

@harryvandijk3347 28 күн бұрын

Hi thanks for the interesting video. I’m about to try this with a handful hoverboard batteries, but I was wondering if it’s applicable to them. The case is that all of them cause the standard hoverboard charger to turn its led off, when I just plug the batteries in a working hoverboard and use the standard charging plug. It feels like the charger led turns off because of a short circuit it encounters, but the batteries are fine with regard to that. They only dropped to as low as a few volts, all of them. Is that too bad or could they still survive with the trick. And is the led turning off just normal due to the way I ‘test’ them? (Ur doing it straight with a psu) Looking forward to your reply!🙂

@rouenwucherpfennig2524 27 күн бұрын

Hi, how’s it going? Thanks for watching my video. What do you need to do is find a label or know the nominal voltage of the battery. Normally the Hoverboard batteries are 36 V. The batteries have to be brought close to 36 V for the BMS to do its job. So you can charge from the main terminals of the battery pack At 36 V and low amps . You must monitor the voltage all the time and the heat of the cells. The voltage will normally climb quite quickly. Hope this helps be careful. It is quite dangerous. Thanks, Rouen.

@harryvandijk3347 26 күн бұрын

Thanks very much. I woke up 2 batteries till now. One this evening which is still charging. With the first one however, the hoverboard turns off when accelerating fiercely. My theory was that the battery’s voltage drops too far upon heavier load, causing the bms to shut down. When you plug the charger in for 1 moment it turn already on again. If that theory is correct, it’s probably because of the battery having decayed during the time it was around 20 volts? (Which means I would have to replace an unknown amount of cells?) thanks, Harry