Spot on instructional video. Going o crank the car tomorrow to see if I get that magic A/C voltage.

Very very informative video sir

Thanks for the info. What type of multimeter were you using? Thanks

Why is there an earth terminal on an inductive sensor? 🤔

Hi!I have a cranckshaft sensor that show 1Mohm resistance,but when cranking the engine i measure 1,5 to 2 ac volts.is it good or bad?

Good video! Worth noting that not all inductive CPS are 2 wire and not all hall effect CPS are "three wire"! There are exceptions to this rule as demonstrated in this video, where the third terminal here is the screen.

Measure the voltage between the 5V reference circuit and the chassis. = 4,8~5,2 V Measure the voltage between the CKP signal circuit and chassis. = 4,8~5,2 V mine connector value is 2.38 V / car not run only turn key start is it bad ?

Absolutely impossible to test cranking on an audi a4 diesel