Hydro Gear Oil Change on Hustler Raptor SD

Рет қаралды 102,674

5 жыл бұрын

DIY for changing Hydro Gear Oil for more info
4 qts of 20w50 SM, SL service - Motor oil
www.hydro-gear.com/service-an...

Пікірлер: 55

@aussiewelder6130 4 ай бұрын

No life story. No waffle on about how your morning was. Just straight to instructions. Very good.

@durdyryder1 9 ай бұрын

Finally someone who gets to the point does the job shows it clearly and doesn't want to act like a puss about it. Someone who isn't concerned about every little freaking detail and worried about being critiqued by the world. Thanks brother

@timbeech2317 4 жыл бұрын

Thanks for the video, quick easy info. 👍🏻

@aquaman0167 3 жыл бұрын

Thanks for the video. This is the same procedure for the Fastrak SDX too. Same filter.

@PaulGruhn 3 жыл бұрын

Thank you very helpful... I will be doing this this weekend.

@oscarchavez8512 Жыл бұрын

Thank you for your great video you saved me money

@theinternets7516 4 жыл бұрын

Great video! Thanks man!

@WeSRT4 3 жыл бұрын

Thanks for the video!

@321CrashandBurn 9 ай бұрын

Great video

@luisbarcenas5330 Жыл бұрын

Good tutorial 👍

@scubasteve3032 2 жыл бұрын

Very helpful! Thanks!

@DerikStillPasinthrough 4 жыл бұрын

Good vid. I actually found it easier to reach in just behind the deck and across to get to the top vent bolt. Had to work each pump from the opposite side for best results. just FYI

@reeseimmanuel526 2 жыл бұрын

instablaster...

@josephsepulvado2048 3 жыл бұрын

Great video man, made the change smooth and easy. Once complete, it was whining as I rode it around, does that whining eventually stop?

@arubanjames 2 жыл бұрын

Check your reservoir to make sure it’s not low.

@mikemorris2159 2 жыл бұрын

great vid. Thanks

@njaimet Жыл бұрын

Great video, question though. It always I have a minor leak from one side. It appears to be leaking from a circular piece towards bottom of transmission. In your video, looking from the left side, just to the right of the filter is a brownish circle, can anyone identify this?

@nelsoninman3678 2 ай бұрын

Great video now I can skip the dealership

@followtherabbit203 3 жыл бұрын

“Oil filder” haha

@AmericanConcrete 8 ай бұрын

The hardest part of this is removing the vent bolt and getting it back in.

@josemar7128 4 жыл бұрын

ami hutler se le cai la banda del la bonba q puedo aser

@MrAirtaz 4 жыл бұрын

Couldn't see how you have it jacked up. I assume the mower needs to remain level during this process?

@Four2NineProductions 4 жыл бұрын

I use a floor jack on the back metal plate, and used jack stand visible in the picture of the vid.

@user-sr8qj4of6d 8 ай бұрын

It would have been nice if you had used a light taking vent plug out

@WBOS72 3 жыл бұрын

Great video. Where did you jack the mower up?

@joek9962 2 жыл бұрын

I'm wondering the same thing. I can't seem to find information on where a safe place is to do this on the Raptor SD.

@Four2NineProductions Жыл бұрын

On the back plate. On the hitch hole

@vanstry 3 жыл бұрын

Do you put the plugs back in before or after you bleed the air from the system?

@garyclayton4765 3 жыл бұрын

Before you bleed the air from the system. Trying to bleed the air without the plugs in would have oil going everywhere.

@Four2NineProductions Жыл бұрын

Put the plugs back

@trinidadrm Жыл бұрын

I have 130 hours changed the oil but not the gear oil and my reservoir is empty what do I put in that matches the factory hydraulic oil?

@dustinowens9806 11 ай бұрын

20W50 oil

@vanstry 3 жыл бұрын

A recent URL would be nice, as the one in the video doesn't exist anymore.

@Stl515273 4 жыл бұрын

Does the whole system take 4.1qt or each side take 4.1qt?

@Four2NineProductions 4 жыл бұрын

The whole system

@thatflippinrabbit954 3 жыл бұрын

Is it 4.1 quarts per side or is that the amount needed for both??

@ElonMuskX 3 жыл бұрын

4 Qt total should do it

@Four2NineProductions Жыл бұрын

Total

@oscarchavez8512 Жыл бұрын

it is recommended to use synthetic oil ?

@Four2NineProductions Жыл бұрын

@rickysheep93 4 жыл бұрын

Can’t find my oil filder anywhere. All I see is my oil filter

@nexushexus4365 4 жыл бұрын

LMFAO

@rickysheep93 4 жыл бұрын

Nexus Hexus 😝

@arubanjames 2 жыл бұрын

You say potato, I say badayda ...

@Four2NineProductions Жыл бұрын

I said it perfectly, you just hear funny 😁

@paruggeri 4 жыл бұрын

What size is your Hustler

@RyanDiederich 3 жыл бұрын

60in deck shows at one point in the video

@evelyn201 Жыл бұрын

what size filter wrench is that?

@Four2NineProductions Жыл бұрын

65/14

@user-se9tk3cn8p 8 ай бұрын

last thing you said (is literally why i came here to watch this video) ... "again, uh, make sure you uh, check the fluid in the reservoir and make sure you have the "correct amount in there"""" :// what is the "correct amount!!!???

@DistrictFire 2 жыл бұрын

Great video! And I love the position of your jack stands. Is there any need to be level for this hydro change ? Some of the posters asked about jacking. This guy has a nice clip of his opinion on jacking and stabilization. kzfaq.info/get/bejne/Y5pknreVrt-cgIE.html