this worked for me. The right side of my roof did not close properly, I opened it manually and closed it manually. Now works as usually. If took it to the dealers, well you know. THANKS

Great video. Helped me with unlatching my top manually

The video was very helpful. The top left side had latched but not the right side. Misaligned the top due to a passenger window malfunction while in the closing sequence. I was able to release the left side hook with the Allen wrench as you described. Next, disconnected the negative side of the battery for 15 minutes and "rebooted" the car. pushing the close button latched the top closed. Held our breath and completed a complete open and close sequence with no issues. Thank you!

this video helped me a lot, thank you

You’re the best, thank you.

Hi Sir, I followed your instruction on closing the lid, now hooking the actuators back together to hook the system back together. Do I need to manually close the locks? Or bleed the system?

My trunk seems to be misaligned. There is a much bigger gap on the passenger side near the top corner of the trunk and the back pillar. The convertible still works and doesn't get stuck or anything but I'm concerned about that gap. How to I realign this?

Thank you. Where are you and Top Hydraulics located?

Thank you for this video. If I manually open the top, can I drive the vehicle as I normally would (without any beeps over 5mph) my Infiniti is my 2nd/3rd car and I can just park it in the garage with the top Down and use it on sunny days..

Great video; finally some good information from somebody who knows what he's doing and demonstrates clearly, helped me understand how the top works.... unfortunately I've got an issue to troubleshoot haha. When trying to open the top electrically, trunk goes up, parcel shelf moves down but stays horizotal, I hear the latches operating, the flappers move by about an inch, and thats it.....it stops in that position. at this point I cannot do anything without restarting the car. After doing so, I can either reclose everything, or move the flappers by another inch. I did this many times until the flaps were fully extended, but then I,m stuck there. I watched videos of the top operating, and it seems like the shelf should get vertical at the same time as the flaps extend.... Is there any condition that could be missing that's causing the movement to stop ? In short, trunk goes up and shelf down. Then flaps move a bit, latch seems to unlock, and it stops there. Any idea what I should be lookin for ?

When I close my top, near the end of the procedure, when the top is latching at the front, I hear a set of 3-4 very quick clicks, as its's locking into place. What is that an indication of, or is it normal / ok?

Thank you so much for this video. Save me a lot of $$ by using 6 mm Allen wrench

❤thank you

I tapped both wire for the flippers. 12 volts to either wire just sparks and doesn’t do anything.

I have an issue with my top. The sequence starts, trunk opens regularly, windows come down, but when it comes to the unlatch part, i hear clicks but no release. I tried the manual way in the video, got it undone, but it won't move anywhere else. I tried continuing the sequence since everything else is working but the unlatch and it closes it up again as if I hit close instead of open. Any suggestions?

I have a 2009 g37 convertible so recently the trunk open light pops on as I’m trying to open the top I took it to a Infiniti dealership and they told me I need a hydraulic pump and want to charge 10,000 to fix it. I know they’re trying to rip me off but I refuse to let them take my money

I don’t want to break my G37 trying this LOL

You really seem to know your business, but this doesn't help me with my problem, which is that the top is stuck in the open position. If I try to drive the car it just continuously beeps until you come to a stop. Is there a way to manually close the top, or at least disconnet the anoying beeping? Thanks

When I try to open the top, in the middle of the operation it just get stuck and don't open or close, then I have to turn off and then turn on the car to close the top, initially it used to show trunk open sign, I don't even try to open it anymore and I'm seeing one side of the trunk flipper is kind of loose. Can you please tell me what might be the problem? Thanks,

When I press the convertible button for the convertible top to open it shows on the LCD screen separator and the motors do not run or Nothing what could that be

I tried lowering my top and it got stuck I closed and opened with the button and a piece popped out from the right side

I got mine closed with Matco computer.

How can you manually open the top if I can’t open the trunk

Can Top Hydraulics work for me, in essence as a paid consultant to help me (I'm pretty mechanical) troubleshoot a non working 2011 G37 hardtop convertible? I bought the car knowing it had a problem...... I would love to have someone knowledgeable about pumps, actuators, etc. working with me.... step by step where possible? Please let me know if this type of service (online, through FB Messenger / Apple Facetime) or over a phone conversation is a possibility.