Install a PVC 3" BACKWATER VALVE in a floor drain 🌧🏡

No video

Install a PVC 3" BACKWATER VALVE in a floor drain 🌧🏡

Рет қаралды 56,347

Күн бұрын

A backwater valve is a backflow prevention device used to prevent outbound water through a dwelling's drain pipes from re-entering "back flowing" into a home. The valve contains a flap that allows water to exit the home, but closes to prevent the back flow into the home.

Пікірлер: 24

@rusosure7 3 жыл бұрын

Good video. I'll be doing new construction and am considering this, just in case.

@marcossalazar5438 2 жыл бұрын

Great video thank you

@sonnynguyen8012 Жыл бұрын

It’s a useful video. Thank you

@twinkiez420 3 жыл бұрын

Could you give me a list of materials that you used ? I’m trying to install this into my own home? Also have you had any problems with it?

@raymondjackson6069 3 жыл бұрын

If you were to install one of these in your back yard, say 8ft down, how would you service it? Great video by the way.

@jbservicellc1886 2 жыл бұрын

Yes they have to be cleaned from time to time

@mariosifuentes5994 Жыл бұрын

Put in in a box , that stick a bit above ground level so never get buried, also need to take flapper off before sending an auger cable down from the house , make sure you mention this to the plumber!!

@mariosifuentes5994 Жыл бұрын

Wait 8 ft below ground ? Shit good luck with that. , they make some that can be serviced even that deep i think, come with a stick that will allow you to take the flapper out

@darwinawardcommittee Жыл бұрын

@@mariosifuentes5994 Mine has an adapter kit you can buy so you can make a riser out of 6 inch pvc. Then you glue a 1 1/2 inch pvc to the flapper assembly (my flapper assembly has a round disk that holds the flapper in place - it’s a Sioux Chief brand). The one in this video appears to have a receptor on the lid for a glued 1 1/2 inch pipe but I don’t see how you would remove and clean the flapper if you can’t reach it. This one looks like an Oatey. I think I purchased this one and returned it for that reason.

@DannebergAcres 2 ай бұрын

DONT !!!!! They can break causing all sorts of issues!

@joaquinlopez997 7 ай бұрын

What's the namebrand of this product ?

@victoryepez4 6 ай бұрын

Backwater Valve

@jesse7jesse7 2 жыл бұрын

I have a valve installed now just have to figure the best way to box it in with an access door on top. Any suggestions? This is in a basement near laundry area where renters may walk around

@dr.drawnstuff1882 2 жыл бұрын

I got one but I am unable to screw the lid back on it has all the threading still I just can’t get it on all the way any tools for suggestions it is a deep dig so it is difficult to get it

@mcylk 3 жыл бұрын

What happens if someone flushes a toilet, runs the washer or takes a shower when the valve is held closed by sewage backing up from the storm drains?

@joonkeum9457 3 жыл бұрын

Technically, ‘usage’ from inside the house end should be kept at a minimum until the street sewer situation returns to normal so this does not happen. I think preventing street sewer backup mess it much better than dealing with a little inconvenience. Btw, nyc has experienced massive flooding due to Ida’s arrival. It is a holy mess.

@kevinadams9468 2 жыл бұрын

A back flow that may open your flapper and allow water to rise up your drains, that's what. Otherwise, just your shower water or crap stuck between the backflow device and your drain heads! Why would you be taking a shower or flushing your toilet under those conditions? Question answered.

@fortescuegr7573 2 жыл бұрын

You cannot install those on the main connectors in Canada. It is illegal. Pretty much sure it is also illegal in mist US states. On the main collector you need to use a normaly open valve

@OneOffization 2 жыл бұрын

@@fortescuegr7573 do you mean the ones that have those little floats on the bottom that will lift up the flap when inbound flow starts to happen?

@fortescuegr7573 2 жыл бұрын

@@OneOffization Yes, exactly, However check with your local town. Some city don't allow any kind of valve on the main water.