This Video will show you that the message you see on driver display is not always accurate. Follow us on Facebook www. testingnotguessing
Пікірлер: 21
@mermer39542 жыл бұрын
Hi pal. Another great video. Thanks. Can I suggest a personal microphone that enables your voice to be heard more clearly. The starting few minutes and also the last parts of the video were hard to hear over the engine noise and the background music noise. My hearing is not what it used to be:)). Cheers
@chekelley68612 жыл бұрын
Good stuff. May want to get a microphone for when you’re a distance from the camera
@wardybasher2 жыл бұрын
Always take something away from the videos and this was no exception. Sound quality wasn’t great on this but with the compressor running in the background I’d struggle to hear even standing next to you. Look forward to the next one.👍
@the_retired_mechanic2 жыл бұрын
Glad you guided us through that one as I was about the dissappear down a rabbit hole with that list of codes.
@peterarries78792 жыл бұрын
Another great video of keeping to the facts and following back 👏 👍🏻
@Franz_giblet2 жыл бұрын
Another great video, these are extremely informative 👌🏻👌🏻
@trevormansfield67402 жыл бұрын
Always pick up something from your videos. Thanks
@myleswaller2 жыл бұрын
He's back
@muhammadhasham319 Жыл бұрын
I have the same issue with my car can you suggest to me what should I have to do?
@paulwilliams10652 жыл бұрын
Nice one Gary.
@motorcareindiaco. Жыл бұрын
Hii Thanks for this Great job. From india
@timbo19751975 Жыл бұрын
Fun fun fun doing a CAS on this engine !!!! Must use the proper JLR fitting too also.
@kevdavies3445 Жыл бұрын
nice one
@malcolmdown91702 жыл бұрын
Don’t know if this makes sense but after it cut out and wouldn’t restart the tachometer was not showing any rpm as the starter motor was clearly spinning the motor over. This made me guess at the crank position sensor as I assume this is where it picks up it’s rpm data. Remember guys I’m only guessing so be kind if I’m miles away.
@intelligentauto7372 жыл бұрын
No you’re dead on the money there, the fact there’s no speed signal being generated the tacho will not react. But, this is not definitive proof, if there was a comms issue from PCM to instrument cluster there would be no activity from tacho.
@timbo19751975 Жыл бұрын
@@intelligentauto737 Not all tacho's will register during cranking.
@motorcareindiaco. Жыл бұрын
I am worried about this problem in my car
@alburns7278 Жыл бұрын
have the same fault, mine wont start at all , any suggestions?
@timbo19751975 Жыл бұрын
Scope the CAS and if sensor appears to be dead then replace it??
@alburns7278 Жыл бұрын
@@timbo19751975 turns out I need a new battery mate , showed loads of different codes
@paulnightingale79385 ай бұрын
Identical to what my jag is doing although I haven't had time to read the codes yet the disc gearbox abs faults all came up I put that down to rolling with the engine off was this the final solution?