thank you, loved your video was having the same problems with my 2003 Grand I bout and have been slowly fixing all the stuff that was neglected and have always had great luck with these old 4.0 built to last forever if you take care of them again thank you great job explaining everything as you went and showing us as you did the job can't wait to see what you got coming up next be safe god bless

I just changed mine. The old ones were the original 23 years old. Had the Chrysler star logo on them. I was coding P0203. Misfiring open circuit #3 cylinder. So far so good. I also put on a Heat shield on the intake, fuel rail and injectors.

Thank you. I am having fuel issues on an old beat up jeep. Your video was quite informative thank you

Just want to point out one thing---the silver round valve thing toward the middle of the fuel rail is actually some kind of pulse dampener that keeps the flow of fuel through the rail more consistent (this according to the repair manual I have). I like your presentation of the steps---thanks!

Americans are so polite! He apologizes for going to look for the can he used, so give us more information.

thanks Ben I did not see previous comments

I thinking of doing this since cylinder 6 keeps misfiring even after i replaced spark plugs and ignition coil

..... Wow.... I discovered your posting today... when after being told by a buddy he could smell gas around my Comanche ... For the longest time, I couldn't see where the leak or smell was coming from... then, today, I noticed the second injector in from the radiator seems to be a bit 'wet' at the top end, and the rail seems to have a 'witness mark' of fuel spray ... ... I believe I found the source of the smell ! ... And, your clip helped relieve a bit of anxiety about doing the repairs needed... I suppose I might as well do the whole set of injectors, while I'm there ... And due to the advice I found ... not fixing it now, can cause worse damage... yikes... And I sure want to see my '88 Comanche 4.0 / 4X4 / 5spd / longbed lasting a long time ..... Regards .....

Thanks for making this video. This will be my project this coming weekend.

Great. Instructions. Thanks.

Hey Ben do you see any improvement in MPG

My jeep pulls everytime in passing 20mph so it’s everytime I’m passing the second shift it says it’s a cylinder misfire Can it be an Injector I just changed the sparks yesterday

Is the fuel pressure damper needed on a new fuel rail?

I've been working on a 2002 that's been laid up for a few years, the fuel rail does have a Schrader valve. Unfortunately the tube where the quick disconnect attaches to rusted completely tbrough, the aftermarket replacement rail does not have a test port. If its an important feature to have you may want to look in yards away from the saltbelt.

Thank you love the videos

Hi. I have a 2000 wj 4.0 I just replaced my fuel injectors with a 4 hole from a one hole, now im getting a code po172 and po175 bank 1 and 2 oxygen sensors, system too rich. Would this be normal for the ECM to reset for the new injectors after driving a bit, or is my fuel pressure regulator not adjusting to the new injectors? I replaced my fuel filter 2 years ago. Not sure if its a regulator fuel filter type?? Isn't my regulator on the middle of the fuel rail?? Thanks.

Did you end of having any issues with these injectors?

How much did you pay for your injectors?

im having the same issues with mine... 2004 GC... just like yours... smelling of gas fumes...rough idle, dies some times... changed the plugs, coil pack ... still idles rough, RPMs go crazy and so does the speedometer, and dies every now and then.... but no check engine light on... was told since no check engine lite on they cat run the codes... was thinking its also the injectors.... or the fuel filter or pump.... i love my jeep and wanna keep it running... ITS PAID FOR... LOL...so i guess i will try the new injectors, and if that don't work, fuel filter... sure wish i had u to work on it... lol...any comments would be helpful.... thanks...

Hey Ben where did you spray the cleaner at before you replaced the injectors?

how did injectors perform? any mpg improvement?

What size tires did you put on your general

I just replaced mine and now I have rough idle and it will die after 5 minutes . I'm clueless as to what's happening and I'm about to swap back my originals.

Could they result in a misfire or cause the jeep to die?

Which is injector 4 ?

The link for the fuel injectors?

Ummm,ummm,ummm,ummm,ummmm

Thumbs 👎🏿 on the chipmunks tho🫣🫶