John Deere 4020 Powershift and a John Deere 830

Рет қаралды 179,613

7 жыл бұрын

John Deere 4020 Powershift with a John Deere 145H five furrow plough followed by a John Deere 830 with a John Deere 77H five furrow plough

Пікірлер: 31

@sixin1 3 жыл бұрын

Whom have I in heaven but you? And earth has nothing I desire besides you. My flesh and my heart may fail, but God is the strength of my heart and my portion forever.

@bobhostetler8548 4 жыл бұрын

I have plowed with a B 530 630 730 I owned two in the seventies never plowed with the 830 am almost 71 should be on my bucket list..

@henryspuria5033 4 жыл бұрын

John Deere.....? more like John Queer. Bob, ive plowed more men than letters in my name and if there is one thing i can tell you about the seventies, it is that puertoricoians are hung like no other

@dixiewishbone5582 4 жыл бұрын

A stock diesel 4020 comes direct from the factory rated at about 94 HP. With a power-shift transmission as opposed to the then more popular syncro-shift there is sometimes a 2-3 HP power loss. IF this tractor is rated at 145 HP it most definitely has a blower or supercharged engine, which it sounds like, the closer the tractor comes to the camera. Love to see a green tractor pull. . Thanks for posting!

@glennspreeman1634 Жыл бұрын

830 developed 40-50% more lbs ft of torque than a 4020. hp is one thing but torque gets you over the hill. now 2 cylinder design was pretty well maxed but still-----

@redstedman 4 жыл бұрын

I pulled 6 16s in furrow with one dual, all loaded, propane injection. 830 is definately doing a job.

@herbhouston5378 3 жыл бұрын

Love the old Deeres... So many times on this kind if video... when there's more than 1 tractor plowin'... they run too close to each other so the trailin' tractor is often changing speed to keep from runnin' into the lead one... Back off!!

@JT-SE-OHIO 2 жыл бұрын

Doesn't sound like it's straining either one to me. Nothing runs like a Deere. I grew up with a little M and have been sold on John Deere's ever since. Ole' John got the job done and I loved the sound of it working. I have a 1974 year model 830 (3 cyl) and it's a lot lighter duty than this older one. It has enough power but not very good traction. When I use the 3 point to lift anything very heavy then I have to steer with the brakes since it doesn't take much to have the front tires in the air. I'm sure if it was weighted down front and rear it would solve both problems.

@jansybear 2 жыл бұрын

We pulled an 18 ft cultivator and our 830 was a better match than the 4020. The the 830 had a gear just right speed and power and the 4020 just didn’t have a gear in it’s sweet spot for that cultivator. 830 had better weight too. 4020 was great seeding tractor.

@plattforminternationalismu1690 4 жыл бұрын

Alte john deer motorbautechnik.... beindruckend... der oder die liegende n zylinder diesel, niedrige drehzahl... die maschinen müssen sehr robust gewesen sein,.... lg.ff.

@ranulfoarias9839 3 жыл бұрын

I remember are 4010 diésel never pulls like are 830 diésel and 4010 gets hot with the plow

@alikurkun5816 3 жыл бұрын

Verygood

@floydrhodesiv5733 10 ай бұрын

That 830 eeighs more yhan that 4029 does . If they would put 2 more wheelwrights on each rear wheel of that 4020 it would be pulling that plow faster than the 830 !

@Moorfieldjj 3 жыл бұрын

Are these two tractors at Harby Museum? Would like an 830, drove one in 1976.

@grahame3740 3 жыл бұрын

Well spotted. Yes they are in the museum but are a used exhibit

@dickopdahl8034 4 жыл бұрын

To bad they dond use colters and set them would pull easier

@jessesyfie7244 3 жыл бұрын

The plow hooked to the 830 is that a 66H 5 bottom? 14 or 16 inch bottoms?

@grahame3740 3 жыл бұрын

The plough behind the 830 is a 77H 5 bottom 14 inch

@jessesyfie7244 3 жыл бұрын

@@grahame3740 you would never pull that with an 830 in my alfalfa clay ground I have here, I can't even with an 856 5 14 inch bottoms, its some hard plowing!