Thank you custom offsets. Great customer service.

Thank you for a very good do it yourself video custom offsets Just did my 10f150 with some 285 tires rides good no rubs An it’s level ✅

I asked him a couple weeks ago about this for my 2010 f150, not only did he message me but he does a video on the exact setup I want. Thanks

Hey brother just a friendly tip, its way faster on these Ford's to mark and loosen the lower control arm and away bars and you can sneak it in and out. It'll keep you from having to take apart a ton of extra stuff. Great video bro!

you make it look so easy. thanks

love the new intro

from Milwaukee but live texas and trust I will bring my truck to you guys.

Love the new promo

good job .congratulations u just earned subscriber

Great job, important is to loose that nut in the tip of the axle, otherwise you cannot lowering enough the arm to put in the shock.

Likingthe new intro

Do you have to unplug the EPAS plugs before doing this? The instruction manual on my rough country level kit suggests too but i'm not sure whats the point. Thanks!

For these levels is it normal when you run the steering wheel all the way right or left it will compress the suspension and pull the front end down?

Nice...Love the install and how to vids especially the sh#ts I never knew !!!!

Hi I have a 2015 f150. I was planning on doing the bds 2.5" leveling kit with the havok H109 20x 10. Would I be able to run 35x12.5 with this setup? Is that possible with some trimming or is that out of the question?

if you run into an issue with the frontend getting too high while towing or a load in the bed, you could install airbags in place of the rear bump stomps in between on the frame and the bed.

can you make a video on a body lift for a 2001 f150

Have you guys done any setups on the full size Chevy Express vans ?

with a level like this or a lift with about a 3" larger strut, would u need new UCAs?

I was just wondering because I put on a 2inch leveling kit on and my front tires seems to wear out on the outside edge of the tires..... so I was wondering should I put on a 2inch spacer on my wheel to have a even wear on the tires?

I'd love to see a Chevy 1500 z71 07-13 2 inch or 3 inch level kit if possible on here for this new series. 👍

How’s it going. I gotta a question for ya. What does something like that cost to have that done. I bought a 2 inch leveling kit for my expedition online but it’s a little more involved than I want to get into what do you think that’ll cost to have somebody do it for me

That’s what I wanna do to mine! Unfortunately I’ve been hesitant and worried to do it.

What's the torque on all the bolts he removed? 300-450 pounds on the lower strut bolt?

You guys should consider updating your youtube playlists to reflect vehicle makes, like a section for dodge/ram builds, section for GM builds, section for fords, be nice to be able to sort that way! Love the videos, keep it up.

Hello awesome video what brand is this kit ?

I have a 2009 F150 King Ranch, are the 2 1/2 blocks on the top of the struts to much. I don’t want to have any trouble with axles and boots !

You guys should do a video on super lift suspension.

What would someone expect to pay (average) for this type of service? I'm only asking because my Son got the leveling kit for Christmas and wants to do this and I would have to have a pro do it as I do not possess the tools.

I have a 2000 Ford F-150 2wd and would like to do a 2in level what would be the ideal choice

Did you guys have to mess around the the 4x4 vacuum?

what I would like to do is add the front leveling kit and then add bags to the back then if I tow something I can use the bags to compensate.

thanks for sharing, definitely more install videos, maybe even with commentary here and there during the process. on an unrelated note...were the drums being played along with the riff, or did the drum track somehow get shifted during mixdown?

So question you don’t have to replace the cams?

How long does this job take? Is $400 high?

Okay so I have a leveling kit on my truck that I installed and I did put 10 wides with a 33-in tire now I have to do major metal trimming on the corner of the fender I watch your fitment gallery and I saw four to six trucks running a Bilstein 5100 adjustable shocks with 20x10s -24 they all say it was minor plastic trimming after watching this video and watching the fitment gallery that's not the case now I cannot return my wheels I wish people could be more honest you should make a video on how wide you could put on the level 2013 Ford F-150 so other people will not make the same mistake

You said 10 wide with 33s. Any offset needed? I'm completely lost when it comes to this lol.

I have a 2016 f150 4x4 super crew , I’m just wanting to know if a 2.5” leveling kit and 33-12.5x22 with a -44 offset will work ? If not what offset would do it . I’m also taken all crash bars out . Please let me know . Thank you 😊

Ok so if I bought the parts what would it cost to have the work done???

When tightening the upper control arm down shouldn’t it be under load or should I just tighten it to spec while it’s still unloaded?? Thanks!!

Great vid! Do you have to do a alignment after installing this?

custom offsets, do you guys sales does leveling kits and how to do you spin it 180 degrees so the bolts up top line up ?

how come you dont need to compress the spring and turn the cap of the coilover? wont the bottom bolt not line up anymore if the top bolts are turned?

ok after the first song the music got good

Does anyone know if I can add a leveling kit on top of 6" suspension lift on 2004 F150 extended cab??? Need some advice (: thanks

After putting the level spacer do u have to put a spacer on the tires and Alignment

Did you have to adjust the camber after installing this leveling kit?

What are the effects of a 2" lift to the ride, handling, mileage and structural integrity?

Doubt I will get a response considering how old this video is, but if you install leveling spacers and want to improve the ride of your truck... should I purchase Bilstein HDs or Bilstein 5100 leveling struts? In theory I haven't changed the length or travel of the setup correct?

On 2010 f150 2wd is the strud the same as a 4wd??

could use some help. tried installing a leveling kit on my 2011 f150. put the spacer on top of the strut and went to install. had to turn the strut 180 degrees cuz of the bolt pattern and went to put the strut back into the top and it didn't want to seat properly. any suggestions?

can 35s fit with rough country level kit

Great info guys,thank you, but how will this effect my towing, I tow a 29 ft. RV weighing in about 8000 lbs. any info would be greatly appreciated

Is 10 wide the max with no rub?

When installing what do you need to watch out for as far as removing the cv axle

what song is that at the begining?

Looking to go to a 35" on my 16 z71, but want to go up minimally in lift. Will a 2.5" leveling kit work? What is better, upper or lower leveling kit?

Do you need a front end alignment after installing the level kit?

The song on repeat was killing me, but it was a good vid

I'm planning on putting 20x12 -44 offset wheels with 33x12.5 tires, would that setup work on a 2 inch level in my 2012 f-150, and what kind of trimming would I be looking at?

How would I go about fitting 35x12.50's in there with only a 2" front level?

If i get a 2.5 inch lift for the front how many inches will i need gor the rear to balance out evenly? Drive 2016 f150 xlt 2wd

i have a c/k 3500 dually and it seats rack as you said with the back higher then the front and i would like to do the same thing that as you guys did to this truck so it can seat leveled in the front or higher then the rear but i couldnt find a leveling kit on your website for a c/k 3500 dually rwd

If I decide to use a 3inch kit instead do I have to change my control arm? 2009 f150 4x4 supercrew.

I just did this and when I drop the suspension knuckle all it’s being held on by is a thin little wire for the brakes. I do not recommend doing this. I was not please with this video after attempting this.

def gotta show some 14-16 chevy silverdoe lift install! def will be going through yalls website to order some stuff!!

I have a stock Ford F-150 suspension. Which one is the right leveling kit.. 2” or 2.5” for front

What about 2'-3' inch lift kits that use a new spindle i/o of spacers in the front? Do they compensate for the increase in angle of the UCA ball joint? What's the main difference?

I just did the same thing to my 09 fx4 and theres more wheel gap in the front then the rear,it looks as you have the same on this truck,now what can i do raise the rear up an inch

I've had a leveling kit (2") on my 2016 f150 and about 2 weeks after it was done it stated creaking. I took it back told them what it was doing and they took it all apart and tightened it all back up. It was fine for about another 2 weeks then it started again with the creaking. Any ideas why? Thanks

if I'm running larger tires and wheels do i need to change gear ratios as well?

I have a 2 inch leveling kit. I was wondering if I install it would it cause positive camper?

First I nothing about suspension stuff but say I wanted to put a bigger wheel on like you said in this video but I tow a lot. Can you lift the rear somehow so I can tow without putting a full lift kit on? If that makes sense to you?

maaaannn after getting the strut out, with that rusted, shitty looking strut top now showing... at least hit that joker with a wire brush and get it looking decent before reinstalling!

That upper ball joint angle though.....lol

Was looking to add a 2" level to my 2021 F150 Lariat Fx4. Would their be any issues/rubbing w 295/70/R18. Will be using the stock 18" - 44 offset rims. Thank you...

Can u add 22x12 with 33 stretched

How much does a leveling kit typically change the ride quality? I have a 2017 F150

Sorry, a newbie question. Does this effect the ride quality? Stiffer ride? 😊

Will they fit on a Ford 150 strut fit on a fordbcrown Strut in the front

And how much do y’all charge

My '14 F-150 already has a level kit i don't know what brand & came with 33x12.5x18. The tires look small. How much bigger & wider can I go without replacing the whole suspension? I wanna keep it leveled not lifted.

I got a 2013 f150 single cab i want to in stall a 3" lift all the way around. I was told that the 3" lift would put alot of stress on my ball joints and that i would be replacing alots of ball joint. Any type of feedback or recommendation would be a appreciate it

does this change the front end alignment or is this just bolt in and go?

Nice video. I noticed the spacer thickness looks a lot less than 2”. Is that normal? Thx guys.

What would the cost be to do this to a 2019 F150?

Wonder what this does to the cv angles and boots when arching the front end down when leveling.

I like the look, how would this affect me towing a 5000 lb trailer? Thanks

To put 20x10 on 2010 GMC Sierra 4x4 3 inch suspension lift work?

Fit for 33s on 2013 4wd f150 with stock suspension?

I have a 3 inch levelling going in is that a good idea or bad ?

I wanna lvl my 17 f150 2wd do I need a 2in lvl or a 2.5in lvl?

I have one simple question is it as simple as 2inch spacer =2inch lift 3inch spacer=3inch lift Sorry if it's a pretty dumb question just curious thanks!!

What does this install cost? Out the door.

Would love to see you guys level a Tundra with some 35s. I got a 15' Tundra with a 3/2 level kit running the 20x9 factory wheels on 33x12.50 Toyo MT and it seems the wheels look a little small for the body size and that level kit from a side view although the front/rear view looks fine and love the streamlined look. Any suggestions on an offset that would possibly work with the setup I've got? I got a little time before treads run out on the mt's but I would like to run another set of 35x12.5 toyo. I really like the ride on those tires. Thanks for any info you might have and I'm really enjoying all the good info this channel provides.

Adding 2” level just like one shown to my 2011 f150 4x4 lariat with 135k miles. Been reading back and forth reviews. Does it change camber enough to need a camber kit? Thanks in advance.

Don't you need a front end alignment, after that?

Did you have to compress the spring and turn the strut?

I followed this guide and now I have a humming noise coming from the front right! Any ideas??????

Could you fit 20x12 after This without much rub on 33”