Limits and homing with LinuxCNC

Рет қаралды 10,231

Жыл бұрын

An introduction to limits and homing in LinuxCNC, covering aggregation of multiple switch inputs onto a single parallel port input pin.

Пікірлер: 10

@geneweber7701 Жыл бұрын

Thanks for posting this video. It clarified what I've been reading. Excellent job.

@stav3322 Жыл бұрын

Great content! Can't wait for future parts!!

@MrStarTraveler Жыл бұрын

That's what I needed to learn! Good stuff.

@joat_mon Жыл бұрын

Good information. Thanks Matt.

@design8studio Жыл бұрын

Cool

@nwbstplyr 8 ай бұрын

what application are you using to draw up your schematics? looks like a fun app to use

@mattsmachinechannel 8 ай бұрын

Hi, the application I use for the interactive circuit schematics is: KTechLab apps.kde.org/en-gb/ktechlab/

@SinedWOLF 8 ай бұрын

7:00 - А я всё никак не мог понять как искать дом в плюс по Z)

@mattivirta 11 ай бұрын

i just build my cnc X axis, limitsSW both end, and home inductive sensor left side X, i configure 2 paraller port card, used, first main port has connected all home axis, XYZ, second paraller port have all limit SW. hard limit, not can go out of linear rails, have better connect all limitSW same pin 10 than E-stop or all limit SW own axis limitSW both side X, both limit Y, both limit SW Z etc. why my first test i call homing X, go to left my home SW, BUT why start go back to right side after connect to home SW, and not stop, need E-stop can stop not run out of rails. what need make ? home X,home Y, home Z, have configured. and all limit SW have top of rail, and configured 2 different style possiple use, all limit same pin than E-stop, or all limitSW pin X11,Y12,Z13. second paraller port card, because one paraller port have only 4 pin can use.10 E-stop, X home,Y home,Z home, and pin 15 probe. what need make configure wisard ??. home axis right ? my X have 0 to 800 ,linear rail dimension, Y 0 to 1000, Z 0 to -300, have this right ? home setting 0.0 search home 1,5 mm/s what need do. homing normal ,if bush button home X then move left to minus but stop then connect home SW.,why run back to right ? and not stop newer, if not bush E-stop run out of rails and broken machine. help please what need do go normal only left and stay stop to home position.if i bush button home X , Z and Y not have tested yet, not all parts have ready.

@mattivirta 11 ай бұрын

or need i buy 6 inductive sensor more(expensive option) and make soft limit too my machine ? i have mechanic hard limit SW 6 pcs, to installed and 3 inductive sensor home SW to X left side, Y front side, Z up side. X left is 0.0 to right 800, Y front 0.0 to back 1000mm, Z 0.0 up to down -300 . have this right at configuration ? i not know. 0.0 have home position.