Yes I actually do. I have a 2003 Cadillac CTS. It's a 3.2l V6 I change my oil very often just because the car is old, 217,000 miles old currently. Anyways, I Used AutoZone oil, so basically STP Synthetic high mileage, and the car runs great with it. I did a oil change last month with the same kind of oil but this time I added that Lucas Low Viscosity Stabilizer. Since then, I can testify that it really does help! I keep noticing it. I'm like dude this car got quiet. Aswell with improvement in driving, when your driving at a steady speed, you can't even hear the car at all and the car keeps accelerating, maintenaning the speed your going at, Very smoothly. Not that it wasn't like that beforehand, it was, but you know it did something when your driving and it hits you, like damn. So yeah definitely helps. I say it has power to quiet your car down a bit and slightly increases acceleration. It does something that affects the acceleration for sure. I felt it was slightly smoother. Not faster, smoother. It's wierd. Like I said, if you know your car, then you use that stuff, you'll notice it eventually. For me, it hit me about a week into it, I'm like yo the car feels good wth. Lol.

I've always used lucas to help with dry starts. It's in all my cars from my 1979 Lemans to my 07 Lexus RX 400h. Obviously I use the low viscosity in the Lexus. All my motors run great and are always clean inside and out

I use it in my Chevy Tahoe and love jt !

You always have great information to share i recommend for people to check out your channel, i know you have used some of these products in videos.

@@NATESINTERACTIVEAUTO Thank you very much. I try my best to observe the products I use.

Do you use synthetic or regular oil?

@@TheRichardF10 yo!! where you at? you haven't posted any new videos in a while!

Chris Armstrong Amsoil is my fave, royal purple ice coolant additive is cool though 😝

ya, you do the recommended amount of the thick stuff in montana when its -40f..... and good luck getting oil pressure even with 5w-30..... it will take about 10 to 30 seconds (modern VS vintage engines....ETC) so if ya add lucas in the winter here..... might take 120 seconds to get above 4PSI lol like.... i know because ive SEEN it happen on the gauge had a BEAT TO HELL 86 pont 6000 2.5 4 banger..... due to previous owners complete lack of care i never changed the oil in that car.... just spun on a new filter it burned and leaked so much oil..... it was basically a "total loss" system it just changed its own oil as ya drove....(of course, ya had to add some back) ran 20w-50 + lucas in that pos..... still went threw about 2 to 3 quarts per ~3000 miles

You help bu sharing your experience with the NIA community thank you

Im really happy to hear this and Good or bad I love when people share their experiences with the NIA community.

Im going to add the heavy duty stabilizer on my 04 f150 with a 3v 5.4 and see what happens

@@georgeeno_2815 well, what happened?

Its not him you are not paying attention

@@Roman-vh1rr yes it is

😂😂😂

No doubt😂

I’m pretty sure that was a Time-lapse

Was thinking the same thing, about 3 quarts shy there bud!

@@jamesmcardle5426 had to have been. Looked like less than a quart came out.

I was thinking the same thing🤔

I have used it before let me know what all you want to see

If it makes engine oil last longer. If it makes engines run cooler. If there is less friction adding it to motor oil

Yeah, what about the Pure Synthetic formula? I have an 05 Civic with V-TEC engine. Can I use that product instead of the low viscosity formula? Car takes 5w-20 oil. Had conflictions answers @ auto parts store, so I'm turning to internet, thanks in advance!

Drain a qt before adding a qt

Extra safety

yes

Yes.... But you must first remove the same amount of oil ounces so that your engine is not overfilled. Yoy can remove thw drain plug amd get the oil oit like that.... Messy but effective.... Or use A manual siphon pump to do the job... Slight modification might be needed with a smaller gauge tubing to fit down your dipstick tubing..... Try to use long enough tubing to connect to siphon pump and have about 6 to 12 inches longer than your dipstick length... You donot want to get that smaller tubing lodged inside your dipstick pipe.... Thats a headache nobody needs. Good luck.

Maybe the air intake. I removed my throttle body and thoroughly cleaned it simultaneously with a filter change. Put it back on and I couldn’t even tell my motor was running at idle.

@@Dmgolfer22 I cleaned my throttle body while it's still intact. Cleaned mass airflow sensor too but check engine comes up after few days.

I use valvoline 5w30 oil, then I used mobile one 5w30 and the engine started ticking. Then I accidentally used 5w20 and the ticking worsened up. Idk what to do. Do I have low pressure? Was the oil too thin? Are they my lifters? I used seafoam in the oil crankcase, I even used fuel injector cleaner

@@NevrrPresntt pour pepsi in the crankcase

I noticed that too....

It was a time lapse

NO, ENGINE TOLERANCE, IS NOT MADE FOR IT!

Yadin Ganon how old ? I have a 1992 mint chev tracker with the 1.6 fi engine I use 10 -30 and a pint of Lucas thick stuff or stp 219000 runs like new no oil consumption change oil every 4000 . I owned it since 1999

New stuff great on my 2000 f250 5.4.

It can be beneficial just follow manufacturer's instructions.

Smalltown Farmer88 I would use rislone first it cleans the lifter and rings gently or wynns engine tune up filling directions and drive gently .

Always use manufacturer's recommendations

@@NATESINTERACTIVEAUTO yes mobil 1, fully synthetic oil !!!

NATES INTERACTIVE AUTO even with a 5.4 3v ? Everyone recommends upping to 5-30

@@joesmith-fi1sx on older engines around the 2000s, they often reccomended thinner oils for Cafe standards and better mpg but most often the engines can use a 20 weight but would be much happier with 30. I took my Honda off 5w20 and went to 5w30 and it's much quieter, much smoother and I use Mobil 1 with Mobil 1 oil filters from Walmart. I feel pretty pleased with the price and quality and how much quieter the engine is

It wasn’t even that much. Wonder if it was a cut in his video?? Strange.

It's was sped up

Yes, I bought a new car last year, GDI AND TURBO. aware all these cars have fuel dilution issues, some worse than others, the..Honda 1.5 lL seems to be the worst. I'm running Castrol edge, and I keep a close eye and snif my dipstick to check for gas. I have no increase on the dipstick, at 3000 miles its still on the full mark, no higher. But I can definitely smell gas in the oil. So 3000 mile oil changes seems a good idea. I bought this car, like it fine, and intend to keep it a long time.

anotae my girl friend self destructed at 89000 kmI emailed a consumer program here in Canada market place she was stalled off by the dealership from 48000 km . She was complaining of stalling knocking oil consumption and smoke so bad on passing it blocked local highway at 48000 they stalled her till the time warrant was up but not the milage . I emailed the dealership and CBC market place with all the records and explained how I drove it passed a car at 50 mph and the smoked caused cars and truck s to stop on the highway because they could not see and they thought we were on fire . The dealership claimed it was the design of the pcv system lolol. Having considerable car and engine skill and my hobby of racing modifications and building engines for boats and car and custom painting I challenged them that environment Canada should take a look in the pollution caused by this design any way after a few email they agreed to replace the short block with a new one n/c.The only problem I drove the 2013 Elantra this weekend its down on power and smokes when passing at 60 mph the hope it not repeating after a year on the new motor .The engine is 1.6 gdi also

Yes it could buy you some time with added protection

@Adam BWould that new "Lucas Low Viscosity stablizer" or what about the "Lucas Full Synthetic" formula work any good @ quieting down my engine noise? The liquid isn't as thick so I don think it'll do much. Car is a slight tick noise. Not sure if it's valves or pisions. Which one of the two would you go with? I'm using Penz oil 5w-20 in another 900 miles next oil change. Thanks bro. Any experience/thoughts?

Chances are you could also need to adjust the valve lash. Old school Hondas like my 02 need it every once in a while, I'm not sure about the 05 though. But yeah Hondas like thicker oil too which keeps em happy longer.

@@redlinearroyo847 ill keep that in mind, thanks

Doubt the Lucas caused that.

Put 0-40 and add lucas

Thanks for sharing your experience and follow manufacturer's recommendations. My self personally i use 0-40 Mobil1 FS for 1 particular vehicle that has history of engine wear.

Thanks for trying to help i myself use particular 0w40 FS Mobil1

The oil i use can be found at Walmart and the FS is in smaller letters on the back.

🤣

Been considering this for my 01' GS430, what model do you drive? Many thanks.

Is it USA made? If not then your a fool.

@@yodead369 Yes Its USA Made,Look Up Motorkote Online.

Kevin Kinsler I use it in my 408000 2004 Grand Prix in powersteering and engine and my 2006 2.8 cts and my 14.5 hp riding lawn mower

The new formula is for vvt engines not the heavy duty it’s way to thick!!

@@kirkleaman6863 I have a 2010 Toyota Matrix AWD, and the New formula did the same thing with my VVT sensor. The Oil pressure warning light would flicker every once in a while until I changed my oil, and then it was fine.

Never use thick ahh oil in a VVT

Congratulations!! This has to be one of the dumbest comments I've ever read on youtube.

@@davidcumbie1035 lol....

Thanks for watching really.