Watch best oil proof kzfaq.info/get/bejne/ptB2ZNZ7mrzJiIE.html

Sub'd. Thanks for all your time in making these videos Nate!

These are the same products I’ve stuck to my whole life.. my 4 bangers dint like the Lucas stabilizer like my v6 and v8 but they like seafoam in the oil and Lucas injector additive in gas. I just never seen a Lucas injector demo like you’re so thank you

You won't notice an immediate difference right when you add the Lucas. Just drive it, let the engine oil/lucas mix up, and then make a video of a cold start with the oil/lucas mixture. I would be very curious. Very great video. I'm actually testing Lucas Heavy Duty Oil Stabilizer in my car and I am going to review it sometime in the future. Maybe in like 2-3 months.

I have used Motor Medic on my 94 chevy pick up for 24 years , I have 314,000 miles on it . The way to use it is have your oil level a quart low , add the flush and run the motor for 6 to 7 mins , then change the oil . This stuff is not transmission fluid

I just add about a cup of Auto Transmission fluid about a week before I change the oil . It has a high detergent factory and helps carry the particles to the filter . When I change the oil , I put the plug back in then add add about 1-2 pints of fresh cheap oil let it sit for a bit then drain that off , you would be surprised at how dirty it is from the remain old oil . Last change I went for some Lucas and some 10-40 Synthetic oil ( normally 5-30 ) . It certainly ran smother and is quite now even after 5,000 mile in a Chevy L77 V8 .with 130,000 miles . BUT I must admit my car starts on Petrol ( in the US is called Gas ) , then switches to LPG. Vehicles I have had that run on LPG ( Propaine ) don't contaminate the oil , it's the fuel that leaks past the rings that breaks down the oil and sludges up an engine . The Lucas stabiliser tends to stay on the cam and lifter so they are lubricated right at the start .

Did you notice any contaminants lol good vid very thorough

Your explanation, very helpful for me my friend,, I’m first time to use this motor medic , Thank you .

Pretty cool demo Nate. I like the dust mask demo of all that came out of the crankcase. Also, is it really necessary to change the Mobil 1 every 3,000 miles? I think you can safely go to 5,000. Advertised to protect for 15,000. Just wondering. Thanks for sharing.

I have my doubts one the stabilizers and some additives but my transmission on my 2007 Hyundai Elantra and all other fluids I need to flush the car was poorly maintained. I want to do a over haul on all the fluids first off . I race the car on dirt tracks I'm gonna put hard miles on it bit I'm a bit worried about some issues about the Hyundai after it hits over 100,000 miles the motor sounds strong bit I'm having trouble shifting and it has trouble going into reverse. It's a 5 speed transmission. I used to race dodges so I'm a little new to the Hyundai game. I'm learning quickly but I'm afraid to hurt or do some cutting to my harness that will later on down the road cause me issues. I'm a bit skeptical. I just want to k ow I have the heater core bare and ready to disconnect I'll get a full 180 pre bent hose so it doesn't collapse on me my main worries are that the transmission gets a proper flush and tune my clutch works fairly well some times I miss second if I hot throws to high it wont shift into second. I take good care of my cars I run them on the track after that its mainly setting. But I'm also starting to hear that knocking too. Its worrying me

You could get the same flush results with a quart of mineral spirits and probably cheaper too. If your changing oil every 3k anything will work. You will get the same result from plain 5-30 as Mobil1. I add a pint of Liquid Wrench to the oil 100 miles before a change to clean the motor out. Drain very well and use a good filter. 200-250 miles later change filter just to be sure it doesn't plug up with anything else breaking free after the Liquid Wrench loosens it. I think the sewing machine sound you have is mechanical though.

Great Comparison Thank you!

1) engine should be Hot, it's written on any Oil Flush i've used ever. 2) Don't worry about oil level when applying Flush. 3) Some engines (such as LS) with high volume of the oil will need 2 bottles of Oil Flush

LUCAS OIL 10001 Heavy Duty Oil Stabilizer is for extra high mileage engines only. Use the Lucas Oil 10130 Pure Synthetic Oil Stabilizer

I’ve been using motor medic motor flush and Lucas since new, I now have 80,000 miles and my engine. It runs like it only has 450,000 miles on it! Thank you motor medic and Lucas!

The only thing I would have done different is to run the Lucas Synthetic additive instead of the regular Lucas if you are using the Mobil 1 synthetic oil.

Ok so I had to stop because of the way you said " Don't Go Above Halfway" , lol you put emphasis on it.. So you can't do that without at least telling us why not... Dying... First video of his I've seen, and I really like this Guy.. Definitely a new Subscriber.. Don't breed em like dat there uh no more... Awesome vid Bruh..

Now i have a 1999 ford ranger , my truck has a knocking sound only when hitting the gas is there anything I can do about that?

Have you ever tested duralube?

I use the whole bottle of flush for a V8 02 explorer. Works great just flush leftover flush with hlf quart of clean oil. Finish draining, change filter and fill back up

Lucas seems to help as engine warms and the gdi fuel pumps are loud

Lol great video, I have used the motor flush with good and bad results, as far as the ingredients of the motor flush I always thought it was 90% diesel lol the ingredients says petroleum products but not how much lol. my bad experience with the stuff was putting it in a high mileage engine that had never been cleaned, it broke the carbon buildup down nod stopped the oil pickup screen in the engine up, I had to pull the oil pan and put New oil pump and screen in it so be carfull, carbon is just as abrasive as sand.

Nice job with the mask, I like it!

I'm glad I use the mobile 1 high milage I will try this additive

I did this about 20 years ago except I changed the oil first added 1 qt of oil then the flush then filled the oil, ran it for 5min or so whatever it said then changed the oil again. It seemed to work fine although the vehicle didn't have problems to begin with it just had high mileage then I did the exact same thing on a vehicle I purchased that had high mileage because the oil looked dirty not long after I changed it. The oil never really got dirty again however it did start leaking oil like crazy. In all fairness it did leak oil beforehand but it got much worse. Anyway I've heard conflicted stories about doing this but I have an old Nissan truck I use around the farm and would like to do this but it has over 350,000mi and I'm kinda nervous about doing it.

I've watched a few of your videos and they are well documented. We don't get many of these products in the UK. Do we have additives you don't get in the states?

you got the cheaper lucas oil. the one i have is non synthetic and its much more thicker, its also easier to mix it in with oil before you pour it in the block it mixes itself up better and wont get gunked up one valves and shit.

Sounds better after adding Lucas. Good video!

This procedure fixed my hemi tick

I have questions do i put motor flush let run then drain it after i put lucas oil stabilizer

it will, because it thickens up the oil, but that isnt the fix, the fix is to change oil regularly, use a good oil and use the recommended oil, a good engine flush followed by an oil change would probably be better, I guess on a high millage car, it doesnt really matter

Good cleaner

Actually cleans

We do this every oil change?

Car sounded like a diesel at first

quieter for sure!

So this stuff makes noises go away, no problems ?

The Kucas oil stabilizer is thick, and modern engines require a thin oil. The synthetic oil everything your engine needs. Unless the engine is burning oil because it is worn out. Thicker oil may not get past the rings and seals as much. Save yourself time and money and just use full synthetic at the mfg recommended viscosity.

sounds good though

I’ve been using motor flush and the Lucas, my car car over 110,000 miles and it runs like it has 60,000 mile on it.

Are you not worried about things clogging the screen or the sump?

You should have used the Lucas full synthetic oil stabilizer the Whitt’s bottle it’s made from regular oil

I really can´t see any sound difference. Maybe the fresh oil was cooler and more viscous. Maybe you knock off some dirt from the filter by rupturing the media with that pink querosene flush.

Motor flush is ATF and Naphtha. ( Kerosine).

I think you need a longer funnel lol

You are caring for older high mileage engines? My old ones get that treatment. I just use a bit of lucas to show coat on dipstick when cold. No more rattle starts! Not too thick in winter.

Just did this except use marvel mystery instead of the lucas. I also added all of the motor flush. Don't know if it damaged anything dont think so, ill update if anything tho.

Hey Nate I've been enjoying the videos. All the bad things I heard about you aren't true at all.

This viddya is about OAL!! 🤤🤤 Merica

Instructions on the motor flush says put in cold engine add full bottle let run for 5min so drain out a quart of oil then add the flush to make the oil level is at the full mark on the dip stick

4 quarts of diesel fuel and 1 quart of motor oil. Run 10-15min and drain. I would like to see how that compairs.

If you are going to do a engine oil flush. You want to do it with fresh oil and filter. And you are doing 2 oil changes. One with flush. 2nd one with out

Used Lucas oil stabilizer and ended up getting a misfire code changed the oil and code went away, never using it again

Sounds terrible AFTER adding treatment

The best oil you can use is valvoline maxlife

Do not add any additives on a cold start make sure you warm up your engine before pouring ur additives

Not good flush and not great oil. I use amsoil. Such a great improvement

Thin out your oil and let it idle for 5 minutes. I would never do that.

Sounds way louder. Just spent money for nothing. Most flushes never work! Sad but true.

Always run a magnetic drain plug oil and trans

What’s the point of not following the instructions… dose not make any sense

I didn't hear any difference.

Sludge usual quiets engine noises, once removed.the party starts

Amsoil is better

I usually flush my engine with diesel or with transmission fluid. Let the car idle for 10 minutes and then drain and fill back up with fresh engine oil.

Lucas Snake Oil.😂

Motor flush. Stay sway from this stuff. If, that's if, you have to use it. Use it on clean oil. I would use Supertech since its good quality oil but cheaper than Mobile 1. Make sure its recommended oil with only half the bottle of flush. ATF on idle for 15- 20 minutes does a safer and better job. You can do 50/50 ATF and engine oil or all ATF. Make sure you add new oil filter before and after.

That Covid 19 haha

Terrible video no before video of engine sound

Save your money and just use a quart of diesel