MKS DLC and CNC Shield WiFi ESP-01

Рет қаралды 1,970

Жыл бұрын

In previous video I explain about Bluetooth module and how to control your GRBL with Smartphone without any USB cable, now in this video I control GRBL laser engraver with ESP-01 module and with no any USB cable.
This video is just an introduction
Schematic of connection included at the end of the video.

Пікірлер: 8

@eslamgamal9176 Жыл бұрын

Wonderful keep going

@manifa59 Жыл бұрын

Thanks a lot ❤️

@ekoharyanto8176 Жыл бұрын

Please tutor cnc arduino Uno R3 built in ESP 8266 built in memory 32 bit

@manifa59 Жыл бұрын

Hi you mean: esp-01 for cnc shield and arduino Uno and control it over WiFi? At the end of the video you can see the link of the tutorial, but how to program esp-01 in an easy way and the easy code to make esp-01 as a AP Telnet will come soon (programming side of this video)

@ekoharyanto8176 Жыл бұрын

@@manifa59 no, there is an Arduino Uno development board that already has esp and 32 bit memory

@manifa59 Жыл бұрын

@@ekoharyanto8176 If you mean this one: www.ebay.com/itm/204141724369 it is esp32 and there are two different grbl versions for it "ESP32-GRBL" and "FluidNC" -------------- For this one: www.amazon.com/10Gtek-Compatible-Development-ESP8266-Arduino/dp/B09K3XY16N nothing available to run grbl frimware on it. ----------- and for this one: m.nl.aliexpress.com/item/32953451236.html?gatewayAdapt=gloPc2nldMsite It can run grbl over Arduino Uno and can be controlled by built-in Wifi (Esp8266) ------- if you mean anything else please link a photo of the board.