Rich nice tips on the recallibration. Great info on the oils and filters. 👍👍

Thanks, Richard!

Thanks for the vid. I like your fuel line grabber. I still love these ultra videos hahah, keep ‘em coming

Going back to work u

Thanks for the video! 👍

Great video, useful information. Thank you.

Fany enough I had an exact fuel filter failed on me today, it had some spongy stuff in that designated and twice blocked my carb screen on a 051 but still pulled. Great video.

Hell yea cool 😎, thanks !

Great m-tronic info👍🏻 one would think all oilers would be left for more right for less! Modded a few stingy stihl oilers over the years. A 660 shouldn't have issues keeping a 28" bar oiled😅

Great Video!

I run the stokel stack(west coast saw) foam filter's and they work great

I put air filters in the ultrasonic cleaner with a 70/30 mix of water and simple green. 10 minutes usually does the trick. Gently blow out (from inside out) with air and set the filter in front of a heater or near a wood stove to fully dry. That’s the best way I’ve found to clean them and doesn’t seem to impact longevity as far as I can tell.

Nice video. I like my chain soaking with oil. Bar oil is cheap insurance. Any brand will work fine. It’s all 30 wgt napthenic or 20 wgt if winter grades.

Stihl also has a pre filter for these air filters. I have them on my saws that have these types of filters.

Man that stuff..had me rolling 🤣..

👍👍 bagus

I had an unpleasant exchange with a self proclaimed industry expert who vehemently denied that Stihl ultra had anything to do with my personal experience seeing this glazing on the saws coming across my bench. After enough back and forth I eventually banned him from our page. Stihl is absolutely terrible stuff and I find it cringeworthy that they feel it's ok to push on their customers.

Richard, I'm sure there's numerous videos, but I'd rather ask you. I have a stihl 170 that if I leave bar oil in the saw it leaks pretty bad. What's the fix for that problem? Thanks for all the great videos.

Am a new subscriber, enjoy all your videos, mainly for educational purposes. I have a Ms 194 Ms 261, two 460's and a new 661 cm, I run all my saws hard full tilt all the time. Very diligent on maintenance, cleaning and the best non ethanol fuel I can get. Not a fan of Stihl ultra, always ran orange bottle hp, never no issues, my question is, is the something better I should be running, don't know enough about Shaffer or amsoil to switch, any input would be helpful. Thanks

The bar and chain (a little l) also.