Myplasm CNC : How I wired and set up my floating head switch. CNC Plasma cutter.

Рет қаралды 3,052

Жыл бұрын

This is my version of how I wired and set up my floating head switch in Myplasm CNC. Hope this makes since and helps someone out. Please reach out if it didn’t make sense to you or you have any questions.
⁣
.⁣
.⁣
.⁣
.⁣
.⁣
#cnc #cnccutting #cnclathe #cncmachine #cncmachining #cncmachinist #cncmill #cncmilling #cncowners #cncporn #cncrouter #cncwoodworking #engineer #engineering #instamachinist #machinist #manufacturing #metalwork #plasmacutter #plasmacutting #primeweld #snowflake #snowman #steelerectors #welder #weldeverydamnday #welding #weldingcaps #weldingshop #weldlife #myplasmcnc #myplasm

Пікірлер: 8

@jenncodesign7570 Жыл бұрын

Thanks for this Chad, I'm sure I;ll need to watch it a few times but I think it will help me out for sure. I'll let you know how it goes. Thanks again

@m3chanist 10 ай бұрын

NC, normally closed, is the better option for everything CNC. After swapping the cable connection, just click invert check box under the relevant input you are using in the software. For the simple reason that it is fault-tolerant, break a cable, got a bad connection to your switch etc and the trigger condition will be set meaning you don't crash your machine driving your torch into the table, same goes for all axis end stops.

@burgingarage 10 ай бұрын

Great advice 👍 Thanks for sharing

@Turningwrenches85 Жыл бұрын

Some good advice there on that cnc

@TylerHarney Жыл бұрын

Would love to see some close up video of the linear movement and such. I like how the rack and pinion was tacked for the Y-axis, I didn't think about that, that would solve my procrastination. Where did you source the rack and pinion? I'm assuming X is driven the same?

@justinrivers5397 7 ай бұрын

Did you design this table? I’ve been looking for some plans to get me started building my own table.

@burgingarage 7 ай бұрын

I did. I built it in September of 2022

@macemcewan588 7 ай бұрын

hi i cant get mine to arc atomically when i hit play i have to hit the space bar everytime the cnc starts to come down to get it to cut ,,, what do u think the problem would be thanks