MZ ETZ 250 joining the crankcases
Рет қаралды 10,628
4 жыл бұрынjoining MZ ETZ 250 crankcases. The continuing rebuild of a race engine to the specification of BMZRC (British MZ Racing Club). Looking for wear on the primary drive. And handy tips on locating the dimples on the oil shields for the main bearings.
@majster_kesz 4 жыл бұрын
Good job ☺
@meckanicall 4 жыл бұрын
A couple of points....Heating the right case up to spitting hot rather than the recommended 100 C will fry the Wellseal on contact...not good. Also it is easier to fit the the right case THEN the oil guide disc which can now be easily located in the correct position, then fit the bearing circlip... then and finally the oil seal which can be positioned on the shaft more carefully...
@stimpetta 4 жыл бұрын
Thanks for the extra tips. I can see how putting the circlip and seal would be easier after the cases are joined.
@derifamatze8599 2 жыл бұрын
what kind of ball bearings have you installed ? Greatings from Germany
@TheMitchellmitchell 4 жыл бұрын
Wellseal to one side of the case only?
@stimpetta 4 жыл бұрын
yes
@user-xq7bj2kt1g 4 жыл бұрын
I want to make my mz etz 250 bike as race bike, how can i do that please explain to me?!
@stimpetta 4 жыл бұрын
Take a look at the Tuning Guide on the Technical Info page of the BMZRC website. bmzrc.net/help-info/technical-info/
@user-xq7bj2kt1g 4 жыл бұрын
@@stimpetta thank u very much i will see this guide and understand the tunning
HFC Shorts
Рет қаралды 19 МЛН
retro2oo_com
Рет қаралды 260 М.
ВАСИЛЛА
Рет қаралды 570 М.