Just a quick video of me putting together the Ortur Laser Master 2 I got to run my Endurance Laser - Mach 3 cannot really do image engraving so I went this route! Links : Ortur Laser Master 2 - amzn.to/37nk38l
Пікірлер: 6
@alpscraftshack5993 жыл бұрын
I am looking at getting an Endurance Laser for my Ortur Laser Master 2. How do you like the Endurance Laser? Have you had any issues / problems / troubles with it?
@HoarderOfHobbies3 жыл бұрын
I have not really had any trouble with the laser itself but the kit I got with the air compressor included, the little converter thingy burned out - but I prefer my own higher powered air compressor anyway so it wasn't too big of a deal
@Tswearinger3 жыл бұрын
how much cutting area did you lose with the endurance laser i am seriously looking at getting one , but they look like alot larger head.
@HoarderOfHobbies3 жыл бұрын
It is a lot bigger and there's a lot of baggage (2 control boxes and a bunch of wire harness stuff) - so I've switched to a much smaller (supposedly) 15W but I seriously doubt it - but it does cut just a hair faster than the Endurance and I haven't tried swapping lenses yet amzn.to/3Bmf8yw
@a2rick2 жыл бұрын
How did you wire your Endurance to the OLM2 board?
@HoarderOfHobbies2 жыл бұрын
I wired the TTL wire that was going to the original laser to the TTL of the Endurance control box and used the power from the Endurance control box... the power that was going to the original laser is just taped off