Things like switches/ ligtb bulbs and associated wiring get loose due to very bad pot holes on the streets. Just to avoid being scammed by auto shops, make sure to check switches wire connections. Carefully disconnect and reconnect them. Carefully because these are quite fragile. Once reconnected, power the vehicle and see if the d light still flashing.

Thanks. You make fixing cars easy and understandable.

Thanks for the education, it was very helpful, wish more people would do that.

Thanks for the video.

Changed it myself on my honda fit 2007. Thanks for the infos👍

Totally awesome very informative thank you!!

Thank you for the video. They need to be oem or aftermarket is good?

I wish KZfaq would allow me to like this video more than once lol. So here in a like and aa sub instead

Very good video. Thanks a million. U just save me some time. Thanks again. Keep up the good work.

THANK FOR YOU TIME AND EXPLAIN

I am very happy with your clear voice I can also understand a little English. Thanking you.

Hello i have a p0845 code should i replace pressure switch for 2nd gear and the 3rd gear?thanks

Thanks for the video. Would like to know if my Honda has 5 gears, then it will have 5 switches?

I got a 03 pilot i dont have any codes but when i go over a bump at low speeds 20mph it disengages from the gear but will engage again when i come to a full stop it happens sometimes but never on high gear on high speeds

I have D blinking with VSA light on together! Any ideas? Thanks in advance

I’m replace mine pressure sensor top that drive light stop flashing after at week star flashing again

Could you tell me what is tha part Number For Honda Fit 2013, Transmission Fluid Pressure Switch A 2nd Clutch. P0843 Code is active in my car.

hi, i have p0842 honda pilot 2011. fluid sensor switch "A" do you have a video for that?

Does anybody know where the 2004 dodge intrepid se transmission fluid pressure sensors located?

My honda crv 1st gen.. when the engine is hot.. d4 blinks and it wont engage anymore.. I have to kill the engine and then re start .. then it runs a bit then des engage again... Already cleaned the solinoids .. replaced atf..

Presure switch A would be?

Hellw

How do you know which one to change ?

I have HONDA ACCORD 2008 MODEL AND ITS GIVE ERROR P0842 AND P0843 .CAN YOU UPLOAD VIDEO OR ANY INFO ABOUT THIS. IT WILL BE HELP 4 ME A LOT TO UNDERSTAND THANKS .❤

Hello my friend, I have a 2020 Honda Civic that has a problem when you start driving at approximately 0.5-1 rpm. It starts to shake a little, and when the rpm rises, the shaking or trembling disappears. Note it has code p0843, transmission fluid pressure sensor/ switch 'A' circuit high Please help me to solve my problem 🌸