Does anyone in this industry ever check piston to cylinder clearance or ring gap tolerance? Not to mention crank - rod bearing slop or wrist pin bearing slop. Seems there is probably a lot of loose engines getting put back in service. How about putting the piston on in the correct direction? The arrow on the piston dome points to the exhaust port. These are fine videos, but there is a lot more fine details to properly inspecting and assembling even a simple two smoker.

I've seen this comment twice but I want to stress it so it gets answered. What oil and mixture rate did John fly the motor at for 350 hours?

sadly i can put only 1 thumbs up..... thanks for the video. I was scared of repairing 2 strokes engine but you make it very simple.

Another Great Video By Aviators.. Alex is a Beast 👍👍🙌🏼

What fuel mixture was he running and what kind of oil? Thanks for the video.

Very grateful you guys are doing this series since I'm pretty sure I'll be getting one someday very soon :)

Excellent video, thank you 👍👍

Don’t forget about the base gasket thickness/head Clarence part😜

Great video, thanks. I'm not sure if you mentioned it, but when I install the Cir-clips I make sure the gap is facing up (towards the top of the piston) or facing down (towards the crank). I have seen cir-clips pop out during highspeed run-ups, and by orienting the gap correctly there will be less of a chance it will pop out.

Great video, thanks for sharing! How can I know which Size of the cylinder gasket to use?

Great video,no bullshit to the point yeah baby!!!!

wow that was one clean top, almost looked like it had been cleaned beforehand. What oil and percentage was used for this engine?

You guys did a video for the carb rebuild cant find it is it still on u tube?

Hey do you know what the squish measurement is on a Vitterazi 185

what oil was used and how much oil to fuel Thanks

Anyone know what the moster 185 compression is supposed to Be? Thanks

Is it just me, but is that black triangle mounting bracket at the bottom of the motor broken?

Very nicely done video, guys. Alex....enjoyed meeting you while visiting Aviator, a few months ago.

Hello!!

Where did Alex get that scissor lift table?

I was hoping for a squish test demonstration. My Moster lost a lot of power after my 100 hr maintenance, and I believe the squish is the problem.