Рет қаралды 29,388
This is my son's KZfaq channel. An honest roofing professional: @allroofusa6762
Watch this video to see how I repaired these leaks: • How to Repair Rusted H...
More videos on Metal Roof Leak Repairs: • Metal Roof Edge Repair...
Metal Roof Seam Repair: • Repair Metal Roof Leak...
Repairing a rusted leak in a Metal Roof. I used a piece of Sheet metal and Turbo Poly Seal to make the patch. Here are links: More metal roof repair - • Repairing METAL ROOF L...
Turbo Poly Seal - bergstromm.com/product/turbo-...
FTC Affiliate Disclaimer - I get commissions for purchases made through links in this post.
0:00 Rust Hole in Metal Roof
0:15 Finding a leak on the metal roof
0:52 Water trapped under the coating
1:30 Preparing for sealant
1:48 Fitting Metal over the Hole
1:58 Using Pan head screws
2:32 Using Turbo Ply Seal
3:47 End Summary
Turbo Poly Seal bergstromm.com/
How to repair the flashing on a leaky flat roof.
Follow these steps:
1. Remove all old caulking and tar that was used to seal the flashing
2. Use an angle grinder with a hard-wire steel cone brush to remove about five inches of paint on the brick or cement wall above the metal flashing
3. Wipe the metal flashing thoroughly with lacquer thinners to remove any residue of silicone from the metal
4. Use masking tape to seal about three inches on the wall above the metal and 2 inches below the grove. (this is for making it look clean when done)
5. Apply one coat of Turbo Poly Seal, covering the entire area between the two masking tapes.
6. While wet, embed the Polyester Fleece into the Turbo Poly Seal
7. Apply a coat of Turbo Poly Seal to cover the entire fleece
8. Wait 10 min and then remove the masking tape.
8. After a few days, the Turbo Poly Seal flashing can be painted with urethane-based paint.