If You find this video helpful, please subscribe! I upload a repair video every week.
In this video, I go over how to test the dynamic brake resistor inside the Precor 932i, a likely cause for error 15. In addition to possible cause for IFT drive failure. If the resistor tests good, and error 15 only comes up occasionally you can probably disregard it. However, if the resistor is bad it best be replaced to prevent more expensive problems.
Link to a multimeter - amzn.to/3w0olZF
Disclaimer:
Due to factors beyond the control of Grim Repair, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Grim Repair assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Grim Repair recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Grim Repair, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Grim Repair.
Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you.