Programming the Bobil Vans Solaris Controller

Рет қаралды 6,779

2 жыл бұрын

The Bobil Vans Solaris controller is a controller which will turn on the electric element when the battery voltage hits a programmable threshold, and turns it off when it drops below a separate threshold. This video shows how to program the controller for your desired setpoints.

Пікірлер: 12

@moonhand8311 11 ай бұрын

Thank you. Nice and clear. What about P3 and O4 This is confusing in the instruction I have

@David_11111 2 жыл бұрын

YAY

@doucet2006 Жыл бұрын

How did you wire it to the mppt or battery side. I am missing this part

@bobilvans4205 Жыл бұрын

If you need support then email us at admin@bobilvans.co.uk

@manoaza09 6 ай бұрын

What is P3 and P4? Do you know maybe?

@theoteam4641 2 жыл бұрын

Do you have a hot water level sensor switch to turn on a valve to open cold water into the tank when it’s low and shut off when it’s high?

@bobilvans4205 2 жыл бұрын

Hi there - do you have the Air Xchange kit? Or the hybrid? The hybrid just automatically fills as it’s a pressurised system. The Air Xchange you can put a float sensor in to fill the tank with cold water.

@theoteam4641 2 жыл бұрын

@@bobilvans4205 I don’t have either, I am building my own hot water tank with a few things from you. I just got a 2 gauge float switch which would control a solenoid valve to allow cold water feed into the hot water tank

@user-ht1yp9qn6e Ай бұрын

I have programmed as explained and notice that the controller does not switch off when the power drops below the 12.7 it stays on? im baffled has anyone any suggestions please

@bobilvans4205 Ай бұрын

Sometimes try power cycling after programming to reset the logic

@user-ht1yp9qn6e Ай бұрын

@@bobilvans4205 how is that done?