here's my SR gun with a .80" power nozzle. still haven't found the model " of it but Im still using vice grips for stops. it runs good and has good distance with the huge nozzle. forward speed is faster than the reverse too.
Пікірлер: 8
@photocontrolАй бұрын
A good runner! The vise grips seem to do a good job. Interesting that it has a faster forward speed, is there some slop in the arm bearings?
@NelsonBigGunP200FanАй бұрын
No the arm seems solid. Could Also be the brake tension was a bit loose. Or maybe the drive spoon isn't adjusted right still. It still works good though
@Chas-vx5cxАй бұрын
Is it possible to slow down the impact of the gun the speed
@NelsonBigGunP200FanАй бұрын
Yes by either tightening the brake tension or adjusting the drive spoon
@NelsonBigGunP200Fan29 күн бұрын
you could also use a bigger nozzle. a Bigger nozzle will push the arm down farther giving it more dwelling time between arm strokes, being that you have enough pressure/flow to use it. This i think may be the limit of my 2 pumps.
@Chas-vx5cx29 күн бұрын
@@NelsonBigGunP200Fan yeah ok I tighten the brake tension it will impact slow but it turns rather fast
@Chas-vx5cx29 күн бұрын
@@NelsonBigGunP200Fan also I have increased size of nozzle running at 110 psi
@NelsonBigGunP200Fan22 күн бұрын
@@Chas-vx5cx adjust the drive spoon out of the stream if you want it to move forward slower. Adjust in the stream if you want to go forward faster. Also if it's a fast reverse you can adjust the reverse spoon to go faster or slower during reverse