Sea-Doo Switch Transducer Mounting
Рет қаралды 2,215
Жыл бұрынVideo of the mounting portion of the Garmin GT56 transducer. This portion probably took me about an hour and a half. If this video helps at all, you could easily cut it down to 30-45 minutes.
#seadoo #seadooswitch #garmin
Tools used:
Drill
7/8”bit hole bit
Heavy gauge wire
Mason bit
3/4” wood bore bit
Painters tape
Pulling string
Propane torch
iPhone level app
@andrewhallmi Ай бұрын
An impact drill never works well with a drill bit fyi. Thanks for the video. It was helpful.
@HeatherRieker Ай бұрын
I am Mike’s wife, and I can confirm this took a while.
@willlarson4063 4 ай бұрын
Thanks for the video. I found it very helpful for this part of the installation. Once inside the port side toon, where did you crossover to get to the helm? Did you have to drill any holes?
@riekermr 3 ай бұрын
I used some cable stays and went right under the aft most panels. Then ran it along/under the panel mounting rails on the starboard side
Jason Derulo
Рет қаралды 58 МЛН
Freshwater Fiend
Рет қаралды 64 М.
Garmin Guru: All Things Livescope And Fishing
Рет қаралды 75 М.
JetBoatPilot
Рет қаралды 95 М.
Sea Doo Switch extreme Tubing
Рет қаралды 20 М.
Tokparty
Рет қаралды 2,1 МЛН
i-shoppers обзоры
Рет қаралды 1,5 МЛН
Sameer Gaming
Рет қаралды 2,5 МЛН