Setting your RC Cars Gear Mesh by Gear Backlash

No video

Setting your RC Cars Gear Mesh by Gear Backlash

Рет қаралды 4,616

Күн бұрын

This method of setting gear mesh is very accurate when done correctly. It will also save you from stripping your gears out. In order to correctly understand where your gear mesh must be, you must be able to feel out the difference between your gears fully meshed and unmeshed.
Next step is to mesh your gears fully and back them out slightly until binding and any noise upon rotation of the gear disappears. With some practice, you can easily get the hang of this. Tighten up your mesh before your hand slips and you are good to go!
How to Set Your gear Mesh in 3 Easy steps (Original Video)
• Video
RC Gearing Explained
• RC Gearing Explained -...
Calculate Torque at the Wheel using the Gear Ratio, Kv, Current:
• Calculate RC Car Wheel...
Gear Mesh Article:
www.radiocontr...
Join the RC Speed Club and Help Support the Channel:
www.radiocontr...

Пікірлер: 24

@3SIfan86 4 жыл бұрын

This is basically how I have been doing it for years. I remember overthinking it in the beginning and this is exactly the video that will help newcomers to the hobby, and the video I wish I had starting out haha. Thank you.

@RCexplained 4 жыл бұрын

Thanks for sharing!

@xibidit 2 жыл бұрын

i put a strip of paper in between the mesh and push it tight, tighten the bolts and pull out the paper.

@colin1992 4 жыл бұрын

Hy ryan, great video about backlash. Ive had issues trying to find a good meshing point myself, this video helps alot.

@RCexplained 4 жыл бұрын

Great to hear! Thanks Colin!

@zonegamma8197 2 жыл бұрын

i like technical jargon very good

@RobytheFlorentine 3 жыл бұрын

thanks, exactly what I needed....but for my lathe :-)

@RCexplained 3 жыл бұрын

Glad I could help!

@mohdkhairulhidayatabdulrah4157 4 жыл бұрын

Hi Ryan. Is good explanation and good knowledge 👍🏻👍🏻

@RCexplained 4 жыл бұрын

Hey, thanks for the comment! Glad you liked it!

@mohdkhairulhidayatabdulrah4157 4 жыл бұрын

RCexplained i have a question about motor timing and i already email you. If you free can you check the email i sent to you. Thanks

@RCexplained 4 жыл бұрын

Replied

@mehmoodkhan275 4 жыл бұрын

Sir I have 64 mm 12 blades EDF 3500 kV can its thrust is enough to fly jet with complete parts total weight 1kg I have 3s lipo battery can jet fly well

@RCexplained 4 жыл бұрын

Hello, it sounds under powered for a jet weighing 1kg. I would expect a 4s setup using a 3300kv motor to push around an 850gram plane at a decent speed. Your project also depends on the type of jet you have?