Great tip! I'll try that next time, thanks.

Hey, thank you so much!

Hello, and thank you. There's nothing special about the uv light. Any uv light source will cure the piece. The stronger the light the faster it will cure.

Hello, and thank you! That is an electro cleaning solution. It is a step that is take before electroplating to prepare the piece.

Thanks! That is an electrocleaning process. It helps clean and prepare the surface for plating. The pen tip is a felt pen plating tip that has been soaked in a 14kt gold plating solution.

@@SterlingKisses Much appreciated!

I use a few different pieces of software. Check out rhino3d or Blender is a free option

@@SterlingKisses blender sounds like a good place to start thanks 🙏

I think the ec200 is better over all. The only thing to note is that it is picky about the initial stage of your burnout. If the kiln overshoots it could cause problems. If your casting house is having trouble with brown, then I don't know if they would cast ec200 any better.

I like the easycast 200 for the detail I can get out of it but both resins perform well. Sounds like your flask temperature might be too high if you are regularly having porosity issues. Could be an investment issue or problem with your burn out schedual too. Make sure your flasks rest for at least 4 hours after investing.

I am facing the same problem porosity in Casting

EC200 is probably the better choice for small pieces.

@@SterlingKisses I saw a vid where the 200 had some Residue unlike the 400. I wonder

@@itailu it probably comes down to burnout. 200 is picky about the initial burnout temperature. My concern with using 400 on detailed parts is that it might be difficult to get a successful print on delicate pieces.

@@SterlingKisses that’s a shame, I mean why can’t one resin give a solution for every kind of model. That skull ring had small detail and was big no? With all the waist of money, time and energy I had with the resins I used I’m starting to regret this adventure.

hi just wondering did you try this resin? if yes how is results with this resin.me as well was trying bluecast x one,a lot of fails .

I'm afraid I don't have any experience with Bluecast or siraya. So far the 200 has continued to work well for me.

When the flask is taken out of the kiln I cast as quickly as possible. After casting I wait about 8 minutes before quenching.

@@SterlingKisses gracias, Thanks, I have been working with blurcast cr3a resin and I have bad results. a texture with holes and I don't know what to do, do you advise me to change to easycast 200?

You do realize it got polished right? smh

@@omagro8267 I was commenting on how detailed the print was that it even reproduced the print layer lines.

3ds max and zbrush

Honestly I just haven't had the time. I'm working on multiple projects right now, some of which I'll be able to show off in the very near future. Thanks for checking in with me though. I really do want to keep making videos and it's comments like this that encourage me to keep going, so thank you.

Hello, the heating chart can be found on the Resinworks3d website.

@@SterlingKisses merci

Hello, if you go to the resinworks3d website you should be able to find a distributor there.