Skidoo 850 3D Rave Valve Servicing Tips

Рет қаралды 18,779

2 жыл бұрын

Пікірлер: 10

@riverrunner4958 Жыл бұрын

What a job I just did mine yesterday absolutely no room to work the steering colum is in the way also oil tank. I loosen the oil tank and slid it over that helped alot. I will never attempt this again dont care how much it cost i will bring it to the dealer next time. I have had five different ski doo 600 carb models and cleaning the exhaust valves where easy and quick on them. I have 4000 miles on my 2018 850 etec valves where not bad I always run xps oil but had an oil leak on the two shafts that's why I did mine. Maybe I should of removed the exhaust and steering colum to do this job not sure how the dealership does it but has to be a better way?

@Rockysaber7129 2 жыл бұрын

How long would you say the whole process took you? Also, what was the total cost for parts?

@Rockysaber7129 2 жыл бұрын

How long would you guess the whole process took? Also what was the total cost in parts?

@bmickle 2 жыл бұрын

Thanks for the video!!! To be clear the service is just a cleaning of carbon build-up on the valves, right? Is it suggested to replace any seals while in there or is that not needed?

@ktajax Жыл бұрын

The service was for oil leaking. He states as such in the first 30 seconds.

@bmickle Жыл бұрын

@@ktajax Yep, got that. Was asking that the service is just cleaning, and not *replacing* anything.

@ktajax Жыл бұрын

@@bmickle The man stated there's an oil leak. There is a gasket in there and anytime you remove a part and there is a gasket of any sort, it's good practice to replace said gasket. So, to answer your original question and to anyone else reading this, yes there is a paper gasket that keeps the oil in the motor that should be replaced.

@frytire 7 ай бұрын

Umm, there's no adjustment at the cable "nut". The adjustment is all in the nuts on the valves

@boblandry6721 7 ай бұрын

Yes there is. Look at where the Rave Actuator Cable connects to the Rave Assy. There is a Nut on the back of the Mtg Bracket that I put red finger nail polish on so that when I pulled everything apart I made sure that the cable was the same length so that I didn’t have to bring the sled to the Dealer and have connect the Buds System to recalibrate the Rave Assembly.

@chriswhiteman3960 6 ай бұрын

That nut is one piece with the cable - it doesn’t adjust or move at all