as a kid, I had one on a stingray with banana seat.

Thanks very much. I'm just refurbishing my dad's 1962 Raleigh Superbe with a four-speed SA FG hub. I'm no expert, so everything's trial and error. I stripped the trigger, cleaned it, and reassembled using two 2BA brass screws and nuts rather than rivets. The bike will get very little use, so the screw shanks shouldn't wear a lot.

Thanks for this video. I enjoy working on old 3 Speeds so it’s always good to see what other people do to get old parts working again. Keep up the good work!

Patience of a saint. Well done, most enjoyable to watch.

What a patient guy. Nice work.

Try it on with cable

I think when assembling the two pins it is important to put the back plate onto a hole and then to press or hammer them into their final position. However, thanks for the instruction!

brilliant ! always wondered how these worked since I was a kid lol

Great video, I just happen to be refurbishing 2 3 speed trigger shifters that I picked up from eBay

hello mate are the sturmey archer 4 speed hubs still available today in this year of 2021?

Great video!! So very helpful!!!! Many thanks!!!!

Super to watch, thx a lot!

Thank you sir

Thankiu. Nice. 👍🚴

Great vid and knowledge, how did you flatten out the drill bit end pls also how does the new wire fit in :) you keep posting i will keep watching Steve NZ

Cool video! Do you lubricate the shifter at all?

What did you clean the plate it to make it go gold coloured? It's a nice touch.

Hi,

Nice effort 👍, Can I get few numbers of shifters for restoration of my 3&4 speed hubs.

Is there a reason you're not greasing everything up before reassembly ??