*Great unit that’s easy to install and use. It’s relatively quiet compared to window units and **Fastly.Cool** , and it cools down our whole living room, side room and bathroom; which is a large space for any unit to cool.*

One of the best video installation instructions I have seen.

Not sure why but I could not get this fan installed. The remote control receiver caused a lot of problems and then the slot screws would go in but not line up with the other holes. I gave up after hours of trying. The video makes it looks so simple! 😢

Okay, so I am not like handy...at all. As of late, however, I have been replacing lights in my house. For the previous 3 ceiling fans, I got a guy to come do them. And for the newest one - 52-inch Madison Ceiling FAn- I was hell bent on doing it myself. YOUR VIDEO MADE IT GO SO SMOOTH. I literally paused the video when you showed the excellent wiring diagram, screen shotted it, and printed itou. I am shocked. I ran into a slight problem with a red wire from my ceiling that wasn't in the instructions or your video. And I managed to figure it out! The fan looks amazing, and you totally rocked out. Will be subscribing!!!!!!!!!!!!!!!!!!!!!

You were a greatttttttt help! Thank you!!!

Hi My old fan was installed without an electric box to mount the housing. It has a hook coming out of the ceiling. Is it possible to mount this fan with the hook method? If so, how? Thank you

What happens if the box in the ceiling is two small and the two screws don’t fit the bracket? Does that mean I have to rip out the box and place a new one in??

Is it possible to run the light without the fan and vice versa?

Your amazing thanks

How many identical fans can be installed in the house and how do you make each remote only operate one specific fan? Thanks

Hi. Can someone tell me how dimmable the light is? Can it go extremely low, as in 5 to 10%? Thanks!

Thanks! Used the vid to be able to change the frequencies of the remotes…as I have 2 of these…and wondered why the upstairs remote controlled the downstairs fan. Stupid installers!

You! Made the fan

I just installed this ceiling fan and everything works fine. The only problem is that when I flip the switch up on a different switch in the room, it trips the breaker. Does anybody know the issue or have a solution?

Is it possible to run the light without the fan and vice versa?

Is it possible to run the light without the fan and vice versa?

Is it possible to run the light without the fan and vice versa?