Try as I might, I could not get even get a ball end hex wrench to seat into the rear action screw far enough to get a good bite on it. Had to remove the mag latch. The good news is that the little plastic tool they ship with the gun to put the mag latch back on works pretty slick, once you figure it out anyway!

Please offer these left handed.🇺🇸

Left handed version of the v2 please

Hey Ruger , Please make a Bisley model of your Wrangler .22 I bet it would sell ..Thank you

This is cool and all ,but when y'all going to come out with a 2nd gen Ruger American Pistol, it needs a refresh already even if all y'all did was make the competition model smaller I would be good with that

I can't get the rear skrew in or out bc there is no clearance let alone for a torque wrench

Only way I can see this new rifle being better is if a wood stock was an option and it was offered in .280rem or .280AI. I can’t wait for the 6 ARC to come out and when it does my savage is history

Please Please Please make a flush mag! If you have to make an adaptor to put in do it ide even settle for less capacity close the bottom up and have a non removable mag if you have too. Removable is nice but not at the expense of the mag and release protruding out of the bottom! I have your m77 mark 2 in a magnum cal it holds 4 that works fine!! It wasn't broken don’t make it “tacticool” make it “ practical”!!!!!

If they want to sell more make the mag flush and you will sell more! I wouldn’t buy one unless they do!