ToLiss A321 with a Real Airbus Pilot: Landing Tutorial X Plane 11

Рет қаралды 24,052

4 жыл бұрын

Join me as we look at the technique for landing the ToLiss A321 in X Plane 11!
I am a real world Airbus pilot with thousands of hours flying the real aircraft and thought it would be fun to have a look at the new detailed simulation of the longest baby 'bus by Toliss. Hopefully you find this useful and it brings another perspective to your simulation. Any thoughts or comments are welcome!
This video is intended for home entertainment only and does not reflect or represent any real world aircraft or airline procedures. It is for home flight simulator enthusiasts only and has no real world application.
--------------------------------------------------------------------------------------------------------------------------
Software used:
X Plane 11
Toliss A321
Avitab:
forums.x-plane.org/index.php?...
Aerosoft Heathrow

Пікірлер: 63

@pa4tim 3 жыл бұрын

Now I know why the virtual plane on the HSI has that shape and size. during the approach you have them laying on top of the horizon, during flare the under side of the vertical part touches the horizon. much more easy then looking at the VS. never noticed that befor. Thanks for this amazing series of tutorials

@hjr2000 3 жыл бұрын

Catching up on your back catalogue @320 Sim Pilot :-) Thanks!

@spydercomputers 4 жыл бұрын

I can definitely tell you’ve done this a time or two. Lol. Very nice landing. Did my first take off and landing in the A321 today. Took a lot of getting used to. Had no idea how to use autopilot or setup my ILS approach to Rwy 09L into KATL. But, manual landing was actually rather easy compared to the 737-800 I’ve been flying.

@320SimPilot 4 жыл бұрын

It is quite a different aeroplane! I do enjoy flying the airbus and I'm sure you will too. Thanks for watching!

@arielf82 4 жыл бұрын

Great tutorial once again. Thanks!

@320SimPilot 4 жыл бұрын

Thank you as always for watching!

@makaveli2tt 3 жыл бұрын

Very helpful sim tutorial. Thanks for sharing

@320SimPilot 3 жыл бұрын

Thank you for your comment Elijah, glad you enjoyed it!

@TheFlightSurgeon 4 жыл бұрын

Hey! Keep up the great content! One question though - can you demonstrate a CAT III procedure landing?

@320SimPilot 4 жыл бұрын

Thanks for watching! More videos to come and that is certainly on the list!

@yannisl8259 3 жыл бұрын

Wow 6 months and no dislikes youre doing great

@Designwrk-yk8ie 3 жыл бұрын

Thanks for all your help. Can you demonstrate how to land on the centre line. Some of us struggle even with no wind. Do we use rudder or? Thanks

@MikesBasementx 2 жыл бұрын

Could you possibly also do a video on the difference between landing the A321 and the A350?

@richardv8416 4 жыл бұрын

A great tutorial that I wish I'd found months ago! You've managed to explain landings in a very simple and understandable way, while providing detailed information on how to master this tricky phase of flight. I really liked that you've covered crosswind landings too. Many thanks, I'm looking forward to your next video. Just had a few questions from the video: How far from touchdown do you normally disengage the AP to make the landing? When would you choose a flap 3 landing instead of a flap 4 landing? Would you use the ailerons into the wind to level the wings while applying the rudder in a crosswind landing? Would you please make tutorials on the different kinds of approach: RNAV, VOR/DME, and circle-to-land at some point in the future? They would be much appreciated.

@320SimPilot 4 жыл бұрын

Thank you and I am very pleased it was useful! I will give short answers as I am going to do a follow up video to answer some questions :) 1. In the conditions shown in the video I would probably disconnect anywhere on the ILS but before 300ft. As it is single pilot I usually leave the autopilot to fly when configuring (gear/flaps etc) in X Plane! 2. Flap 3 has its uses but needs a longer runway as you land faster with less drag. I shall talk about it in my video. 3. The flight control law on the airbus should keep the wings level when applying rudder, you can see I used aileron to put the upwind wheel down first but that was all. Again a more detailed answer in the video I shall make. This is all unofficial of course and just for us flight simulator enthusiasts! Thank you for the requests, I shall add them to the list.

@richardv8416 4 жыл бұрын

@@320SimPilot Many thanks for the answers to my questions. I look forward to your follow up video to complete the picture - my landings are coming along very nicely thanks to your help! :). Would you mind discussing the differences between landing the 319, 320 and 321 in your follow up video? I wondered if you'd start the flare a bit lower than 30ft with a smaller and lighter aircraft. Thanks again.

@320SimPilot 4 жыл бұрын

@@richardv8416 Of course I shall discuss that too then!

@richardv8416 4 жыл бұрын

@@320SimPilot Thank you...

@heshamfwazz 4 жыл бұрын

Very much appreciated thanks!

@320SimPilot 4 жыл бұрын

You are very welcome!

@peterlazuric5641 3 жыл бұрын

Let me see if I got this right. For a left Xwind landing on final instead of using left rudder for crabbing could you use left aileron, no more then 7 degrees and right rudder to keep the nose straight for final approach and flare.

@evau.alfredhummer7305 4 жыл бұрын

brilliant video and very educating. I also have the toliss A321. How is your opinion on the flight model ? Please also make some RNAV approaches and keep on doing these videos. Would like to see i.e. LPMA, LOWI

@320SimPilot 4 жыл бұрын

Thank you for watching! I think it is very good in lots of ways, I am still discovering more about it as I go, but the FBW feels natural to me so far. I will ad RNAV to my list of videos to come!

@Dg-zj6jo 4 жыл бұрын

amazing views on landing from outside aircraft great sim x plane and great teaching as per. did you get tcas working i got a proximity warning when i was close to another aircraft in the tolliss so it does work

@320SimPilot 4 жыл бұрын

Thanks for watching as always and yes I did thanks to the help!

@z3r0pl4yz7 4 жыл бұрын

Thank you very much for those video! One video idea would be to cover non precision approaches like ndb and vor/dme that would be amazing

@320SimPilot 4 жыл бұрын

You are welcome, and yes a VOR video is due out tomorrow I hope!

@z3r0pl4yz7 4 жыл бұрын

320 Sim Pilot that would be amazing, thanks for your work!

@srivatsa9335 4 жыл бұрын

13:30 observe how car drivers on the bottom left drive like maniacs in the roundabout

@320SimPilot 4 жыл бұрын

Good spot!

@srivatsa9335 4 жыл бұрын

@@320SimPilot pls check our my X-Plane vids if you can 😄

@AvioMan 4 жыл бұрын

Beautiful!

@320SimPilot 4 жыл бұрын

Thank you! Cheers!

@Andromeda_456 3 жыл бұрын

My landings are usually good enough in terms of V speed, but I usually am too far off from the centerline. I usually correct this sort off by using the rudder, but the middle landing gear ends up next to the centerline, whereas the nose wheel will end up at the centerline because of the rudder correction I’m doing. However, I want both to be in the centerline, is it better to use the ailerons for that? Or do I just have to apply more rudder?

@zaxzaxerly9207 4 жыл бұрын

Top video!

@320SimPilot 4 жыл бұрын

Thanks!

@J-L_Pilot 11 ай бұрын

I have problem getting my speed down for the approach, what step do you take?

@colinhunt1095 4 жыл бұрын

Hi. Thank you. Another brilliant tutortial A321 video. Could I just ask if you do leave the auto pilot engaged untill only 300 feet above the ground, or in real life, do you disengage the A/P further out from the runway?. Please keep these exellent videos coming. Regards.

@320SimPilot 4 жыл бұрын

Thank you for watching. In real life it depends on the weather, if you are visual and what sort of landing it is. In the conditions in the video probably a bit earlier! I will provide a more in depth answer in a future video soon :)

@FISS007 2 жыл бұрын

Why the system calls 'tire' just before touch down ? Is it a blown tire or it simply means that the tires have touched the ground ? Thanks =D

@speedplug2360 3 жыл бұрын

nice i will be a a321 pilot but rn im in flight school

@GeorgesFSVideos 4 жыл бұрын

Hey there, I have the Toliss. I am just wondering do the controller sensitivity settings and curves help in anyway, and if they do what do you recommend for buttering and landing the aircraft well and realisticly!

@320SimPilot 4 жыл бұрын

I must confess so far I haven't changed the settings for the sidestick, so default for the Thrustmaster HOTAS 4. This has felt pretty good to me for flying with the sidestick. However I am finding the rudder too sensitive so will have to try and change it!

@GeorgesFSVideos 4 жыл бұрын

@@320SimPilot ok thanks I have the hotas joystick too! Thanks for your feedback

@jackgregory9189 4 жыл бұрын

How common is it in real life to land with flaps 3 and what would effect wether you would or wouldn’t? Great video :)

@320SimPilot 4 жыл бұрын

I shall answer more in depth in a video but it might be used if windshear was expected on approach. Flap 3 of course needs more runway to land but in the A321 I quite like it for landing.

@viocirlan3106 3 жыл бұрын

Hi, I have a question if you don’t mind. So how can I do the approach phase without continuously decreasing altitude with the Altitude Knob? I just want the autopilot to follow the data from the FMGS (and descent according to the STAR). But all it does is just following what the knob says. Can you help?

@yannisl8259 3 жыл бұрын

When close to the top of descent (about 5-10 nm) select a lower altitude and push the button. Set it to the lowest altitude and it will go. First it decend at 1000 fpm until it reaches the required descent path

@elupena 4 жыл бұрын

i have setup of thrust reversers for xplane11, but it is not working with toliss. how do you do your reverses?

@320SimPilot 4 жыл бұрын

Hi Edward. I currently use 'F1' to select reverse. In the ToLiss plugin menu, on the 'sound/actions joystick' tab there is an option called 'F1/F2 can toggle reversers'. I use this so when my thrust levers are at idle I press F1 to start Reverse thrust. When my thrust levers are at reverse idle I can press F2 to go back to forward idle. I hope this helps!

@DanielRlr 3 жыл бұрын

Hello! First of all, thanks for the great video. I keep wondering what I'm doing wrong, because I don't ALWAYS have the problem, only sometimes. Correct QNH is turned in, diamond is visible, I press APPR and activate AP2, the aircraft turns towards the final, but immediately afterwards it turns right off course and flies away from the ILS, so to speak. As soon as I deactivate APPR again, it comes back halfway on course, as soon as I activate APPR again, it turns away again. What's going on there? I'm really desperate. : / Thank you and have a nice evening sir

@britishairways744 3 жыл бұрын

I had same problem maybe ot is wrong course change it to runway in radio menu

@DanielRlr 3 жыл бұрын

@@britishairways744 i only have this Problem with TOLLIS 319

@britishairways744 3 жыл бұрын

@@DanielRlr same I have both I did now do appr on a321 works fine I would recommend just use a321 if you have it

@Oscar-gl6hu 4 жыл бұрын

Where do you tune the ils frequency and put the course in?

@320SimPilot 4 жыл бұрын

Thanks for watching! Normally on the FMGC RAD NAV page. If you put a flight plan in it will automatically tune it as you get near your descent.

@Oscar-gl6hu 4 жыл бұрын

320 Sim Pilot Thank you! You definetly earned a sub. :)

@320SimPilot 4 жыл бұрын

You are welcome, thanks for the sub!

@kingneptune737 3 жыл бұрын

Hello sir, since you've been using tolis a321 for xplane 11 since the start, do you think that it's the best option available currently?? For xplane. If so, please share your opinion, also shed some light on the flight factor a320..., thanks for your awesome videos. I'm a trainee pilot C172 😅😅✌

@CameTo 4 жыл бұрын

Thanks for this. decieding to buy this or the A319 version. We live in the west in 21st century where anytime we say anything we preface it with qualifiers and suffix more qualifiers, for legal, snowflake, PC and of course the troll. This is my opinion only today, and only to be taken as such. I might not agree by the time you read this.

@320SimPilot 4 жыл бұрын

I do not have the A319 so sadly cannot compare. My understanding is the standards are very similar between the two products. Thanks for watching!