Thanks buddy. I needed this. Class

The F is a feild wire to make the alternator start charging, and the S is for sencing battery voltage

Originally the alternator was bad so I had that replaced. Now APU is giving off code 61 low battery voltage. I checked both fuses and they looked ok. I’m going to thermal king tomorrow to get some 3amp fuses it could be possible the fuses could just be old. If the fuses aren’t the problem what else could it be?

I did a alternator and a starter change on my International truck,, I of course unhooked the batteries and my Apu is not starting it keeps throwing a bat or bad code I believe it's the Sensing wire but I do not know how it is hooked up Thank you for your help in this matter I really miss my Apu

Can u do a video on how to change the alternator on the tripac evolution please

I have a problem with my tripack. It was starting and working for 10 min and shutoff with red triangle and Alt sign but after i cleaned the terminal it wont even crank

My truck has an APU but it has problem starting. It’s keep trying to star but after two or three tries it shows a red light in the Cab. (Engine Fault) any recommendations?? Thank you!!

My apu not start up pump clicking and alt sigh comes on i change alternator still same not crank alt sigh Any suggestions

i already ask this question on other of your videos but ill ask again but i haven got answer ye just checking if you or someone else could help me with my problem with my apu run for 5 to 10 minutes and shut down the alternator is pushing 13.9 volts, i just did apm with om parts and still doing that all fuses are good fans both working good, red light on code egn do you have idea what else could be?

I had two additional wires together in the middle and they were attached to the lug right above the harness that has a cap on it in this video. My new aftermarket alternator didn’t have that lug when I connected it somewhere Else the alternator went wild and started goin over 16 volts. Then I disconnected it and it operated fine. Any idea what those two are for. Two white wires together end in eyelet

Hi My APU is running but not changing my batteries. Would you please give me an idea of what is going on? Thanks

Прошлым летом мой APU работал отлично. Зимой решил почистить соединения аккумуляторов, видимо тогда я что-то не правильно подсоединил. До сегодняшнего дня не включал. А сейчас показывает аларм код 61. Проверил sen мультиметром - 0.00. Что может быть? Сегодня смотрел схемы проводки - вроде бы все правильно подсоединено. Но все еще 61 код стоит.

I need your help I got a new alternator but it doesn't charge the battery

Hey I have issues with my apu. The engine cut off every 3min. And code AL3. I checked big fues i clean up all wires on alternator looks like alternator is working when starting engine voltage goes up no problem just keeping shutting off. What's can be? Please help.

Hello :…. I replaced alternator…… but still getting alt code….. could You help me…. Thank You.

The computer module on mine under the bunk doesn’t light up anymore looks like a computer motherboard with fuses

Thanks my apu is not charging my batteries

Я за год спалил 4 генератора, какой то дольше,какой то меньше но итог один Any ideas pls?

А для чего они вообще нужны, я его отключаю, APU заводится и работает но батарею не заражает, подключаю тоже работает, батарею не зарежает видимо генератор здох