troubleshooting tankless part one

Рет қаралды 58,090

Plumbing Solutions, LLC

Күн бұрын

Пікірлер: 34

@user-xy4oy9xl4o 5 ай бұрын

Great Video. I now know what I need to do for the maintenance of my Rheem Tankless heater.

@PlumbingSolutionsLLC 5 ай бұрын

Glad it was helpful!

@pistolasnine8389 8 ай бұрын

Thank you! Great video and instructions 👌

@quangvu4449 3 ай бұрын

VERY INFORMATIVE... THANK YOU VERY MUCH!!!

@MzladyGrinn Жыл бұрын

This video has been a big help for me! Thank you, so much!

@kelseybone3114 3 ай бұрын

Any suggestions on how to fix a fill error on a ruud combi boiler?

@steiner1942 11 ай бұрын

Really Good. Have a Navien and it just went dark on me. No power to controller. Slight drip from actual Water heater outer casing!! Unplugged, going to open it and see what is leaking, possibly fried the unit?

@jap4499 8 ай бұрын

Hello did you figure out what the issue was to the controller?

@wackyfours Жыл бұрын

Sweet

@UncleSamSpeaks Ай бұрын

Thank you!

@amandaturner1114 Жыл бұрын

What about this water heater not turning on at all?

@joeorlando94 7 ай бұрын

Mine - the pressure regulator for the natural gas was stuck. Just tapped the regulator with the handle of a screwdriver and the water heater fired up.

@PlumbingSolutionsLLC 7 ай бұрын

surprisingly that has fixed the problem for me so many times .

@timbrowning6822 5 ай бұрын

We have a Rinnai that from time to time stops working after a few minutes. We have no codes and it just reads the 120. It doesn’t happen all the time. We also just had it serviced and the tech said he couldn’t find anything wrong. Any suggestions what our problem is? Thanks

@PlumbingSolutionsLLC 5 ай бұрын

Water savers in shower heads, something is slowing the flow,

@FlawlessNavi Жыл бұрын

I get Code 12, P1, 12, then P1 again. Any idea what that could be?

@PlumbingSolutionsLLC Жыл бұрын

I'd say water savers in your shower heads. Code 12 is a flame out. It was burning then it quit. P1 is low water pressure. So, something is restricting it. check the filter on the bottom of the heater too.

@DiegoPerez-hh2sz Ай бұрын

How about error code 52? It says something about checking the harness for the solenoid.. but what is the solenoid.

@PlumbingSolutionsLLC Ай бұрын

It's the gas valve. those don't normally go bad. probably got some corrosion on the connection, unplug it and plug it back up..

@melissadee3 11 ай бұрын

What about 29? Can I fix it?

@PlumbingSolutionsLLC 11 ай бұрын

That a condensate code. check the condensate drain line.

@VladRonin 2 ай бұрын

Thank You for video. I have Eccotemp 45 hi - natural gas water heater . Have code E 3. All is OK. Water pressure, gas, vent is clean .. HOW to reset that code.. I Turned OFF power for all day, dont helps. Thanks

@PlumbingSolutionsLLC 2 ай бұрын

Um, normally turning the power off for a few seconds does the trick. Eccotemp has a tech support number you can call, it's probably really simple.

@VladRonin 2 ай бұрын

@@PlumbingSolutionsLLC I DID BEFORE MANY TIMES. Heater was Off all nigh, but stil coming E 3 Code...

@daleadams9323 Жыл бұрын

what is code 24?

@PlumbingSolutionsLLC Жыл бұрын

that is a bad remote or remote wires

@timbrowning6822 5 ай бұрын

We have removed the water savers in the shower heads

@PlumbingSolutionsLLC 5 ай бұрын

Did it fix the problem?

@timbrowning6822 5 ай бұрын

It worked for three showers. The water starts hot for about five minutes then goes cold. Then the next day the shower stays hot?I think my tankless is bipolar?