How to Replace Front Sway Bar Link 2002-2006 Honda CR-V

No video

How to Replace Front Sway Bar Link 2002-2006 Honda CR-V

Рет қаралды 20,369

Күн бұрын

Buy Now!
New Sway Bar Link from 1AAuto.com 1aau.to/ia/1ASS...
This video shows you how to install sway bar links on your 2002-2006 Honda CR-V. Sway bar links connect the sway bar (stabilizer bar) to other suspension components. They have a movable joint that can be damaged or wear out over time. When that happens, the joints get loose, and rattle.
This process should be similar on the following vehicles:
2002 Honda CR-V
2003 Honda CR-V
2004 Honda CR-V
2005 Honda CR-V
2006 Honda CR-V
Tools you will need:
• Pry Bar 1aau.to/ofZ/1AX...
• 14mm Wrench 1aau.to/of3/1AX...
• 17mm Wrench 1aau.to/of3/1AX...
• 17mm Socket 1aau.to/ovb/1AX...
• 19mm Socket 1aau.to/ojq/1AX...
• Ratchet 1aau.to/owV/1AX...
• Socket Extensions 1aau.to/ovb/1AX...
• Torque Wrench 1aau.to/on3/1AX...
• 5mm Hex Socket
Subscribe: / @trq
Check out our playlist:
Honda CR-V 2002-2006 2nd Generation: • Honda CR-V 2002-2006 2...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 17

@TRQ 2 жыл бұрын

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

@Kyle-jg4up Жыл бұрын

Love your videos. The close up to the parts is awesome😊

@seansmith4440 Жыл бұрын

Hey friends. Big thanks for all the videos you guys do! Helped my many times.

@richardking4514 3 ай бұрын

I managed to get the first nut off from each side with an impact. Then my back started hurting while I struggled with the other nuts so I dropped the sway bar and took it to the work bench. An extra step but made the job a lot easier.

@damiank.8214 2 ай бұрын

Best tutorial. Thanks !

@dermot4064 Жыл бұрын

Just did this and the sway bar bushings, no more clunks!

@TRQ Жыл бұрын

+Dermot Thanks for the feedback! 1aau.to/m/Shop-TRQ

@covidcash3326 Жыл бұрын

Short n sweet to the point, thanks

@justinjohnson6092 Жыл бұрын

Is it possible to just lift one side at a time if I don’t have a shop? Or does the whole front end need to be off the ground to relieve the pressure on both sides?